How To Fix RSODSO_UPDATE030 - No QM actions possible for request '&' in DSO '&'; start U state '&'

SAP Error Message - Details

• Message type: E = Error

• Message class: RSODSO_UPDATE - Messages for loading DataStore objects

• Message number: 030

• Message text: No QM actions possible for request '&' in DSO '&'; start U state '&'

What causes this issue?

With a write-optimized DataStore object, you cannot change the status of
a request manually.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Delete request &V1& from DataStore object &V2&, correct it any incorrect
data, as required, and load the request again.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RSODSO_UPDATE030 - No QM actions possible for request '&' in DSO '&'; start U state '&' ?

  The SAP error message RSODSO_UPDATE030 indicates that there are no Quality Management (QM) actions possible for a specific request in a DataStore Object (DSO) due to the current state of the request. This error typically occurs during the data loading process when the system is unable to perform the necessary QM checks or actions on the data request.
  Cause:
  
  
  Request State: The request is in a state that does not allow for QM actions. The states can include:
  
  U (Unconfirmed)
  C (Confirmed)
  Other states that may not permit QM actions.
  
  
  
  QM Configuration: The DSO may not be properly configured for QM actions, or the necessary QM settings may not be activated.
  
  
  Data Issues: There may be issues with the data being loaded that prevent QM checks from being performed.
  
  
  Transport Issues: If the DSO or its related objects have been transported, there may be inconsistencies in the configuration.
  
  
  Solution:
  
  
  Check Request State: Verify the state of the request in the DSO. If it is in the 'U' state, you may need to confirm the request before QM actions can be performed. You can do this through the Data Warehousing Workbench or the relevant transaction codes.
  
  
  Review QM Settings: Ensure that the DSO is configured correctly for QM actions. Check the settings in the DSO and make sure that QM is enabled.
  
  
  Data Validation: Validate the data being loaded to ensure that it meets the requirements for QM checks. Look for any inconsistencies or errors in the data.
  
  
  Reprocess the Request: If the request is in an incorrect state, you may need to delete or reprocess the request. This can involve:
  
  Deleting the request if it is not needed.
  Re-running the data load process to ensure that the request is created in the correct state.
  
  
  
  Check Transport Logs: If the DSO has been transported, check the transport logs for any errors or warnings that may indicate issues with the configuration.
  
  
  Consult Documentation: Refer to SAP documentation or notes related to the specific DSO and QM actions for any additional troubleshooting steps or known issues.
  
  
  Related Information:
  
  Transaction Codes: You may use transaction codes like RSA1 (Data Warehousing Workbench) to monitor and manage your DSO and requests.
  SAP Notes: Search for relevant SAP Notes in the SAP Support Portal that may address this specific error or provide additional troubleshooting steps.
  Community Forums: Consider checking SAP Community forums or other user groups for similar issues and solutions shared by other users.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.