How To Fix RSD_TREX430 - Average of attribute &1 from table &2 (DB and BWA) in tolerance range

SAP Error Message - Details

• Message type: E = Error

• Message class: RSD_TREX - Messages from TREX Aggregate Area

• Message number: 430

• Message text: Average of attribute &1 from table &2 (DB and BWA) in tolerance range

What causes this issue?

The average of the attribute <(>&<)>1 of table <(>&<)>2 was calculated
from the values that are saved in the BWA and on the database,
respectively. The two average values were compared. During the
comparison, a small deviation was found. This is tolerable though, due
to inconsistencies that occur in the float fields.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RSD_TREX430 - Average of attribute &1 from table &2 (DB and BWA) in tolerance range ?

  The SAP error message RSD_TREX430 typically indicates an issue related to the data retrieval process in SAP BW (Business Warehouse) when using the TREX search engine. This error message suggests that there is a discrepancy in the average of an attribute from a specific table, and it is being compared against a tolerance range.
  Cause:
  
  Data Inconsistency: The average value of the specified attribute from the database (DB) and the BWA (Business Warehouse Accelerator) may not match within the defined tolerance range. This can occur due to data inconsistencies or discrepancies between the two data sources.
  Data Load Issues: If there were issues during the data load process, such as incomplete data or errors in data transformation, it could lead to mismatches.
  Configuration Issues: Incorrect configuration settings in the BW system or TREX settings may also lead to this error.
  Indexing Problems: If the BWA index is not up to date or has not been properly rebuilt, it may cause discrepancies in the data retrieval process.
  
  Solution:
  
  Check Data Consistency: Verify the data in both the database and BWA. Ensure that the data is consistent and that there are no discrepancies.
  Rebuild BWA Index: If the BWA index is suspected to be out of date, consider rebuilding the index. This can often resolve issues related to data retrieval.
  Review Data Load Processes: Check the data load processes to ensure that they are completing successfully without errors. Look for any logs or error messages that may indicate issues during the data load.
  Adjust Tolerance Settings: If appropriate, consider adjusting the tolerance settings to allow for minor discrepancies, but this should be done with caution and understanding of the data implications.
  Check Configuration: Review the configuration settings for both the BW and TREX to ensure they are set up correctly and aligned with best practices.
  Consult SAP Notes: Look for any relevant SAP Notes or documentation that may address this specific error message or provide additional troubleshooting steps.
  
  Related Information:
  
  SAP BW Documentation: Review the official SAP BW documentation for insights on data consistency checks and troubleshooting data retrieval issues.
  SAP Community: Engage with the SAP Community forums to see if other users have encountered similar issues and what solutions they have found.
  SAP Support: If the issue persists, consider reaching out to SAP Support for assistance, especially if it is impacting business operations.
  
  By following these steps, you should be able to identify the root cause of the RSD_TREX430 error and implement a suitable solution.