How To Fix RSCNV820 - Required Unit &1 for Key figure &2 is not present in infocube

RSCNV820 - Overview

• Message type: E = Error

• Message class: RSCNV - Messages class for Metadata Remodeling Toolbox

• Message number: 820

• Message text: Required Unit &1 for Key figure &2 is not present in infocube

What causes this issue?

The Unit characteristic which is required for the key figure is not
present in the infocube.

System Response

Remodeling cannot be performed.

How to fix this error?

1. Add the required Unit characteristic to the infocube before adding
the key figure in the same remodeling rule as one more operation.
2. If the Unit dimension table doesn't exists then remodeling cannot be
performed.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

RSCNV820 - Details

• The SAP error message RSCNV820 indicates that a required unit for a key figure is missing in the InfoCube. This typically occurs during data loading or when trying to access data in the InfoCube where the key figure is expected to have a specific unit of measure associated with it.
  
  Cause:
  
  Missing Unit of Measure: The key figure in question is defined to require a specific unit of measure, but that unit is not present in the InfoCube.
  Data Model Mismatch: There may be a mismatch between the data model and the data being loaded, where the unit of measure is not correctly defined or is missing.
  
  Configuration Issues: The InfoObject for the key figure may not be properly configured to include the necessary units of measure.
  Data Source Issues: The data source from which the data is being loaded may not provide the required unit of measure.
  
  
  Solution:
  
  
  Check InfoObject Configuration:
  
  Go to the InfoObject maintenance (transaction