How To Fix RS_B4H_TRANSFER_APD092 - Unit '&1' not found for InfoObject '&2' in ADSO fields.

SAP Error Message - Details

• Message type: E = Error

• Message class: RS_B4H_TRANSFER_APD -

• Message number: 092

• Message text: Unit '&1' not found for InfoObject '&2' in ADSO fields.

What causes this issue?

If field is added into ADSO based on InfoObject that requires
unit/currency this unit/currency field must also be present in ADSO. If
it is not InfoObject assignment of added field is removed to prevent
activation error.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RS_B4H_TRANSFER_APD092 - Unit '&1' not found for InfoObject '&2' in ADSO fields. ?

  The SAP error message "RS_B4H_TRANSFER_APD092 Unit '&1' not found for InfoObject '&2'" typically occurs in the context of Advanced DataStore Objects (ADSO) when there is an issue with the unit of measure (UoM) associated with a particular InfoObject. This error indicates that the system is unable to find a specified unit for a given InfoObject during data transfer or processing.
  Cause:
  
  Missing Unit of Measure: The specified unit of measure (UoM) for the InfoObject is not defined in the system.
  Incorrect Configuration: The InfoObject may be incorrectly configured, or the unit of measure may not be properly assigned.
  Data Inconsistency: There may be inconsistencies in the data being loaded, such as missing or incorrect unit values.
  Transport Issues: If the InfoObject or its associated units were recently transported from another system, there may be discrepancies in the configuration.
  
  Solution:
  
  
  Check Unit of Measure Configuration:
  
  Go to the transaction code CUNI (Unit of Measure) in SAP.
  Verify that the unit of measure specified in the error message exists and is correctly defined.
  
  
  
  Review InfoObject Settings:
  
  Use transaction code RSA1 to access the Data Warehousing Workbench.
  Navigate to the InfoObject in question and check its settings, especially the unit of measure assignments.
  
  
  
  Data Validation:
  
  Check the data being loaded into the ADSO to ensure that all required fields, including units of measure, are populated correctly.
  If you are using a data source, ensure that the source data contains valid unit values.
  
  
  
  Transport Check:
  
  If the InfoObject was recently transported, ensure that all related objects (including units of measure) were also transported correctly.
  Check for any missing transport requests that may have affected the configuration.
  
  
  
  Reprocess the Data Load:
  
  After making the necessary corrections, attempt to reprocess the data load to see if the error persists.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or notes related to the specific InfoObject and unit of measure to ensure compliance with best practices.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  SAP Community: Engage with the SAP Community forums for insights from other users who may have encountered similar issues.
  Debugging: If the issue persists, consider debugging the data transfer process to identify the exact point of failure.
  
  By following these steps, you should be able to identify and resolve the cause of the error message related to the unit of measure in your ADSO fields.