How To Fix RQ216 - Run program &1 again before going live

SAP Error Message - Details

• Message type: E = Error

• Message class: RQ - Messages for Cash Management and Forecast

• Message number: 216

• Message text: Run program &1 again before going live

What causes this issue?

An error occurred as entries were being made in table T038P
(This table is new for Release 4.6A)

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Execute the program again before going live. You can execute it as
often as you like, even when after going live.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RQ216 - Run program &1 again before going live ?

  The SAP error message RQ216 ("Run program &1 again before going live") typically occurs in the context of the SAP system's transport management or during the preparation for a go-live scenario. This message indicates that a specific program or transaction needs to be executed again to ensure that all necessary configurations, data, or objects are correctly set up before the system goes live.
  Cause:
  
  Incomplete Execution: The program or transaction referenced in the error message may not have completed successfully or may have been interrupted.
  Missing Data: There may be missing data or configurations that need to be addressed before the system can be considered ready for production.
  Transport Issues: There could be issues with transport requests that have not been properly imported or activated in the target system.
  Pre-Go-Live Checks: The system may have specific pre-go-live checks that need to be satisfied, and this message indicates that one of those checks has not been met.
  
  Solution:
  
  Re-run the Program: Follow the instructions in the error message and re-run the specified program (replace &1 with the actual program name). Ensure that it completes successfully without errors.
  Check Logs: Review the logs or output of the program to identify any issues that may have occurred during its execution. Address any errors or warnings that are reported.
  Verify Configuration: Ensure that all necessary configurations and settings are in place. This may involve checking customizing settings, master data, or other relevant configurations.
  Transport Management: If the issue is related to transport requests, ensure that all necessary transports have been imported and activated in the target system. Check the transport logs for any errors.
  Consult Documentation: Refer to SAP documentation or notes related to the specific program or transaction for any additional steps or requirements that may need to be fulfilled.
  Engage Support: If the issue persists after following the above steps, consider reaching out to SAP support or your internal SAP team for further assistance.
  
  Related Information:
  
  SAP Notes: Check SAP Notes for any known issues or updates related to the specific program or transaction that is causing the error.
  System Logs: Use transaction codes like SLG1 (Application Log) or ST22 (Dump Analysis) to check for any related logs that might provide more context on the error.
  Pre-Go-Live Checklist: Review any pre-go-live checklists or guidelines provided by your organization or SAP to ensure that all necessary steps have been completed.
  
  By following these steps, you should be able to resolve the RQ216 error and proceed with your go-live preparations.