How To Fix RPLM_RECORD_RESULTS010 - Characteristic &1: Inspected scope does not correspond to requested scope

SAP Error Message - Details

• Message type: E = Error

• Message class: RPLM_RECORD_RESULTS - Messages for Results Recording for Portal Role

• Message number: 010

• Message text: Characteristic &1: Inspected scope does not correspond to requested scope

What causes this issue?

The inspection plan defines to what extent the number of valid recorded
inspection values must correspond to the planned number in the field
<LS>To Be Inspected</>.

System Response

The value entered for this inspection characteristic is not allowed. The
processing of the characteristic (sample) cannot be completed if you do
not adhere to the inspection scope.

How to fix this error?

Check and, if necessary, correct your entry.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RPLM_RECORD_RESULTS010 - Characteristic &1: Inspected scope does not correspond to requested scope ?

  The SAP error message RPLM_RECORD_RESULTS010 indicates that there is a mismatch between the inspected scope and the requested scope for a characteristic in the context of recording results in Quality Management (QM) or similar modules. This typically occurs during the inspection lot processing when the system expects certain characteristics to be evaluated but finds discrepancies in the data.
  Cause:
  The error can arise due to several reasons:
  
  Mismatch in Characteristic Definition: The characteristics defined in the inspection plan do not match those that are being evaluated in the inspection lot.
  Incorrect Inspection Lot Configuration: The inspection lot may have been created with different parameters than those defined in the inspection plan.
  Changes in Inspection Plan: If the inspection plan was modified after the inspection lot was created, it may lead to inconsistencies.
  Data Entry Errors: Manual entry errors during the recording of results can also lead to this issue.
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Inspection Plan:
  
  Verify that the inspection plan associated with the inspection lot is correct and that all required characteristics are defined properly.
  Ensure that the characteristics in the inspection lot match those in the inspection plan.
  
  
  
  Review Inspection Lot:
  
  Check the details of the inspection lot to ensure that it is configured correctly and that it corresponds to the inspection plan.
  If necessary, recreate the inspection lot based on the correct inspection plan.
  
  
  
  Adjust Characteristics:
  
  If there have been changes to the characteristics in the inspection plan, ensure that these changes are reflected in the inspection lot.
  You may need to adjust the characteristics in the inspection lot to match the current inspection plan.
  
  
  
  Data Entry Verification:
  
  Review the data entered for the inspection results to ensure that it aligns with the expected values for the characteristics.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on handling this error in your version of SAP.
  
  
  
  Contact Support:
  
  If the issue persists after checking the above points, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: You may use transaction codes like QA32 (for displaying inspection lots) or QE01 (for recording results) to investigate the issue further.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide patches or updates.
  Quality Management Module: Familiarize yourself with the Quality Management module in SAP, as understanding its functionalities can help in troubleshooting similar issues in the future.
  
  By following these steps, you should be able to identify and resolve the cause of the RPLM_RECORD_RESULTS010 error message.