How To Fix RMXTSTABI063 - Build.block &1: Quantity of stor.cond. exceeds quantity of initial sample

SAP Error Message - Details

• Message type: E = Error

• Message class: RMXTSTABI - Messages for Stability Study in TMS

• Message number: 063

• Message text: Build.block &1: Quantity of stor.cond. exceeds quantity of initial sample

What causes this issue?

You have defined storage conditions and an initial sample when editing
the stability study building block.
The current quantity of storage conditions is viewed as the default
quantity per inspection. The total quantity required for the inspections
is multiplied by the number of planned inspections from the inspection
plan that was assigned. These quantities are then added together for all
storage conditions and are not allowed to exceed the quantity of the
initial sample.

System Response

The stability study building block cannot be assigned or copied and
assigned.

How to fix this error?

Correct the stability study building block so that the quantity of
storage conditions does not exceed the quantity of initial samples.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RMXTSTABI063 - Build.block &1: Quantity of stor.cond. exceeds quantity of initial sample ?

  The SAP error message RMXTSTABI063, which states "Build.block &1: Quantity of stor.cond. exceeds quantity of initial sample," typically occurs in the context of quality management and inspection lot processing. This error indicates that the quantity specified in the storage condition exceeds the quantity of the initial sample that was defined for the inspection lot.
  Cause:
  
  Mismatch in Quantities: The quantity specified in the storage condition (e.g., for a specific quality inspection) is greater than the quantity of the initial sample that was taken for testing.
  Incorrect Configuration: There may be an issue with how the inspection lot or the storage conditions are configured in the system.
  Data Entry Error: A user may have mistakenly entered an incorrect quantity for the storage condition during the inspection process.
  
  Solution:
  
  Check Inspection Lot: Review the inspection lot to verify the quantity of the initial sample. Ensure that the quantity of the storage condition does not exceed this amount.
  Adjust Storage Condition: If the storage condition quantity is incorrect, adjust it to match the quantity of the initial sample or ensure that it does not exceed it.
  Review Configuration: If this error occurs frequently, review the configuration settings for quality management and inspection lot processing to ensure they are set up correctly.
  Recreate Inspection Lot: If necessary, you may need to delete and recreate the inspection lot with the correct quantities.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on handling inspection lots and storage conditions.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes such as QA32 (for managing inspection lots) or QA11 (for recording results) to investigate and resolve the issue.
  Quality Management Module: This error is related to the Quality Management (QM) module in SAP, which deals with quality inspections, sampling, and storage conditions.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a functional consultant who specializes in the Quality Management module.