How To Fix RMPU102 - No control cycles were found

RMPU102 - Overview

• Message type: E = Error

• Message class: RMPU - Messages for Pull List (from 4.0)

• Message number: 102

• Message text: No control cycles were found

What causes this issue?

You want to stage materials with event-driven KANBAN or with WM release
order parts. For this type of material provision, you must have created
the appropriate control cycles.
The system could not find any control cycles using the selection
criteria you entered.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check your selection criteria. If necessary, also check whether control
cycles have been created.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message RMPU102 - No control cycles were found ?

  The SAP error message RMPU102, which states "No control cycles were found," typically occurs in the context of Production Planning (PP) or Material Requirements Planning (MRP) when the system is unable to find any control cycles for the materials or production processes being analyzed. Control cycles are essential for the planning and execution of production processes, as they define how materials are managed and produced.
  Causes:
  
  Missing Control Cycle Configuration: The most common cause is that control cycles have not been defined for the relevant materials or production processes in the system.
  Incorrect Material Master Data: The material master data may not be set up correctly, leading to the absence of control cycles.
  Plant or Storage Location Issues: The control cycles may not be assigned to the specific plant or storage location being used in the planning run.
  Data Inconsistencies: There may be inconsistencies or missing data in the configuration that prevent the system from