How To Fix REBDCA072 - Measurements for object &1 still contain errors

SAP Error Message - Details

• Message type: E = Error

• Message class: REBDCA - Messages for Master Data - General

• Message number: 072

• Message text: Measurements for object &1 still contain errors

trados re -> re.tmw

What causes this issue?

The measurements for object &V1& still contain errors relating to the
architectural assignment.
The architectural measurement may not be sufficient for the partially
assigned rental objects. It is necessary to make a special check of the
objects.

System Response

Measurements are not
adjusted automatically. You cannot set the status to
<AB>OK</>.

How to fix this error?

Check all of the partially assigned rental objects manually, and adjust
the measurements.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message REBDCA072 - Measurements for object &1 still contain errors ?

  The SAP error message REBDCA072 indicates that there are errors in the measurement data for a specific object (denoted by &1). This error typically occurs in the context of SAP's Real Estate Management (RE) or other modules that deal with measurement data, such as the Controlling (CO) module.
  Cause:
  The error can be caused by several factors, including:
  
  Incomplete or Incorrect Data: The measurement data for the specified object may be incomplete or contain invalid entries.
  Data Consistency Issues: There may be inconsistencies in the data that prevent the system from processing it correctly.
  Missing Master Data: Required master data for the object may be missing or not properly configured.
  Technical Issues: There could be technical issues in the system, such as problems with the database or application logic.
  
  Solution:
  To resolve the REBDCA072 error, you can follow these steps:
  
  
  Check Measurement Data:
  
  Go to the relevant transaction (e.g., REBDCA) and review the measurement data for the object specified in the error message.
  Look for any missing or incorrect entries and correct them.
  
  
  
  Validate Object Configuration:
  
  Ensure that the object (e.g., a property or cost center) is correctly configured in the system.
  Check if all required master data is available and correctly set up.
  
  
  
  Use Error Analysis Tools:
  
  Utilize SAP's error analysis tools to identify specific issues with the measurement data.
  You can use transaction codes like SE11 (Data Dictionary) or SE16 (Data Browser) to inspect the relevant tables.
  
  
  
  Reprocess Measurements:
  
  If you have corrected the data, you may need to reprocess the measurements. This can often be done through the same transaction where the error occurred.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the specific module you are working with for additional guidance on handling measurement errors.
  
  
  
  Contact SAP Support:
  
  If the issue persists after following the above steps, consider reaching out to SAP support for further assistance. Provide them with the error message and any relevant details about the object in question.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as REBDCA (for managing measurements) and others related to the specific module you are working with.
  SAP Notes: Check the SAP Support Portal for any notes related to REBDCA072, as there may be specific patches or updates that address known issues.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify and resolve the underlying issues causing the REBDCA072 error in SAP.