How To Fix R7B244 - Key figure &1 is an attribute of characteristic &2, but unit &3 is not

SAP Error Message - Details

• Message type: E = Error

• Message class: R7B - BW Metadata (InfoCube, InfoObject, InfoObject catalog)

• Message number: 244

• Message text: Key figure &1 is an attribute of characteristic &2, but unit &3 is not

What causes this issue?

The units InfoObject from key figure &V1& was changed to &V3&. Key
figure &V1& is also used as an attribute of characteristic &V2&. The
units InfoObject &V3& is not an attribute of characteristic &V2&,
however.

System Response

Key figure &V1& cannot be activated.

How to fix this error?

Include the units InfoObject &V3& as an attribute for characteristic
&V2&.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message R7B244 - Key figure &1 is an attribute of characteristic &2, but unit &3 is not ?

  The SAP error message R7B244 indicates that there is a mismatch between the key figure and its associated unit in the context of a characteristic. Specifically, it suggests that the key figure you are trying to use is defined as an attribute of a characteristic, but the unit you are trying to apply to it is not compatible or not defined for that characteristic.
  Cause:
  
  Key Figure Definition: The key figure you are working with is defined as an attribute of a characteristic in the data model, which means it should not have a unit associated with it.
  Unit Assignment: You may have inadvertently assigned a unit to a key figure that is not supposed to have one, or the unit you are trying to use is not defined for that key figure.
  Data Model Configuration: There may be a configuration issue in the data model where the key figure and its associated unit are not properly aligned.
  
  Solution:
  
  Check Key Figure Definition: Review the definition of the key figure in the SAP BW (Business Warehouse) or SAP HANA model. Ensure that it is correctly defined as an attribute of the characteristic and that it does not require a unit.
  Remove Unit Assignment: If the key figure is indeed an attribute, remove any unit assignment that you may have applied to it. This can usually be done in the InfoObject or data model settings.
  Review Characteristic Settings: Check the settings of the characteristic to ensure that it is correctly configured to work with the key figure. Make sure that the characteristic is set up to handle the data type of the key figure.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the key figure and characteristic definitions to ensure compliance with best practices.
  Testing: After making the necessary adjustments, test the data model or query again to ensure that the error is resolved.
  
  Related Information:
  
  SAP BW/4HANA: If you are using SAP BW/4HANA, ensure that you are familiar with the latest modeling practices and guidelines.
  Data Modeling: Understanding the principles of data modeling in SAP BW, including how key figures and characteristics interact, can help prevent similar issues in the future.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  If the issue persists after following these steps, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.