How To Fix QP093 - Formula &: referenced characteristic & is a calculated characteristic

SAP Error Message - Details

• Message type: E = Error

• Message class: QP - Message IDs for function module group QPAA

• Message number: 093

• Message text: Formula &: referenced characteristic & is a calculated characteristic

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message QP093 - Formula &: referenced characteristic & is a calculated characteristic ?

  The SAP error message QP093 indicates that there is an issue with a formula in the context of quality management, specifically when dealing with characteristics in a quality inspection plan. The error message states that a referenced characteristic is a calculated characteristic, which means that it cannot be directly used in the formula as it is not a basic characteristic.
  Cause:
  The error occurs when:
  
  You are trying to use a calculated characteristic in a formula where only basic characteristics are allowed.
  The formula is incorrectly set up to reference a characteristic that is derived from other characteristics rather than being a direct measurement.
  
  Solution:
  To resolve the QP093 error, you can take the following steps:
  
  
  Check the Formula: Review the formula you are trying to use and ensure that it only references basic characteristics. Remove any calculated characteristics from the formula.
  
  
  Modify the Characteristics: If you need to use the calculated characteristic, consider whether you can adjust your approach. You might need to create a new basic characteristic that captures the necessary data or modify the existing characteristics.
  
  
  Use Basic Characteristics: Ensure that all characteristics referenced in the formula are basic characteristics. If you need to perform calculations, consider doing them outside of the formula or using a different method.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for guidance on how to properly set up formulas and characteristics in quality management.
  
  
  Testing: After making changes, test the formula again to ensure that it works without triggering the error.
  
  
  Related Information:
  
  Quality Management (QM) Module: This error is specific to the QM module in SAP, which deals with quality planning, inspection, and control.
  Characteristics: In SAP QM, characteristics can be basic (directly measured) or calculated (derived from other characteristics). Understanding the difference is crucial for setting up inspection plans correctly.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional context or solutions.
  
  If the issue persists after following these steps, it may be beneficial to consult with an SAP expert or your organization's SAP support team for further assistance.