How To Fix QP088 - No original value recording for calculated characteristic &

SAP Error Message - Details

• Message type: E = Error

• Message class: QP - Message IDs for function module group QPAA

• Message number: 088

• Message text: No original value recording for calculated characteristic &

What causes this issue?

Because original values are used in the formula to calculate the
result, the use of original values must also be defined for the
calculated characteristic.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check the formula or the control indicators for the calculated
characteristic.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QP088 - No original value recording for calculated characteristic & ?

  The SAP error message QP088, which states "No original value recording for calculated characteristic &," typically occurs in the context of Quality Management (QM) when dealing with characteristics that are calculated rather than directly measured. This error indicates that the system is unable to find the original values that were used to calculate the characteristic in question.
  Cause:
  
  Missing Original Values: The original values that are required to calculate the characteristic are not recorded in the system. This can happen if the original measurements were not taken or if they were not saved properly.
  Configuration Issues: There may be issues with the configuration of the characteristics in the Quality Management module, particularly with how calculated characteristics are set up.
  Data Entry Errors: Incorrect or incomplete data entry during the inspection process can lead to this error.
  Master Data Issues: The master data for the material or inspection plan may not be set up correctly, leading to missing links between the original values and the calculated characteristic.
  
  Solution:
  
  Check Original Value Recording: Ensure that the original values for the characteristics are being recorded properly during the inspection process. You may need to review the inspection lot and the associated results.
  Review Inspection Plan: Check the inspection plan to ensure that the calculated characteristic is correctly defined and that it references the appropriate original characteristics.
  Inspect Configuration: Review the configuration settings for the calculated characteristics in the Quality Management module. Ensure that the settings allow for the recording of original values.
  Data Entry Verification: Verify that all necessary data has been entered correctly during the inspection process. If any original measurements are missing, they need to be recorded.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on handling calculated characteristics and their original values.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  Related Information:
  
  Transaction Codes: You may use transaction codes like QA32 (Display Inspection Lot) or QA11 (Record Results) to review inspection lots and results.
  Quality Management Configuration: Familiarize yourself with the configuration settings in the Quality Management module, particularly those related to characteristics and inspection plans.
  SAP Community: Engage with the SAP Community or forums for additional insights and experiences from other users who may have encountered the same issue.
  
  If the problem persists after following these steps, it may be beneficial to consult with your SAP support team or a qualified SAP consultant for further assistance.