How To Fix QMIP_EA240 - Value assignment type &1 is not valid for plant &2

SAP Error Message - Details

• Message type: E = Error

• Message class: QMIP_EA - QM: Inpection Planning - Insp. Plan and Master Insp. Chars

• Message number: 240

• Message text: Value assignment type &1 is not valid for plant &2

What causes this issue?

You want to assign a property to the inspection operation. However, this
property is configured such that the validity area category "Plant" does
not appear in the material/plan assignment. This means that there is no
entry in the material/plan assignment of the inspection plan with the
plant that is stored in the validity area category of the property.

System Response

The characteristic cannot be copied.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QMIP_EA240 - Value assignment type &1 is not valid for plant &2 ?

  The SAP error message QMIP_EA240 indicates that there is an issue with the value assignment type in the context of Quality Management (QM) in SAP. Specifically, it means that the value assignment type specified is not valid for the plant indicated in the error message.
  Cause:
  
  Invalid Value Assignment Type: The value assignment type you are trying to use is not defined or not valid for the specified plant in the system.
  Configuration Issues: There may be a configuration issue in the Quality Management module where the value assignment types are not properly assigned to the plant.
  Master Data Issues: The material master or inspection plan may not have the correct settings for the value assignment type in relation to the plant.
  
  Solution:
  
  Check Value Assignment Type: Verify that the value assignment type you are using is valid for the specified plant. You can do this by checking the configuration settings in the Quality Management module.
  Configuration Settings:
  
  Go to the configuration settings for Quality Management (Transaction SPRO).
  Navigate to the relevant section for defining value assignment types and ensure that the type is correctly assigned to the plant.
  
  
  Review Master Data:
  
  Check the material master data for the material in question. Ensure that the value assignment type is correctly defined.
  Review the inspection plan associated with the material to ensure that it is set up correctly.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for specific details on value assignment types and their configuration.
  Contact SAP Support: If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like MM03 (Display Material), QP01 (Create Inspection Plan), or SPRO (Customizing) to check and modify the relevant settings.
  SAP Notes: Look for any relevant SAP Notes that might address this specific error or provide additional guidance.
  User Roles and Authorizations: Ensure that you have the necessary authorizations to make changes to the configuration or master data.
  
  By following these steps, you should be able to identify and resolve the issue related to the QMIP_EA240 error message in SAP.