How To Fix QIE_COMMON015 - Table &1: Error in inspection rule with GUID &2 from the source system

SAP Error Message - Details

• Message type: E = Error

• Message class: QIE_COMMON -

• Message number: 015

• Message text: Table &1: Error in inspection rule with GUID &2 from the source system

What causes this issue?

When distributing inspection rules, the system determined that the
inspection rule with the <DS:GLOS.93B516C7C56C114DA2C8089870E7AA75>GUID
</> &V2& cannot be copied from the source system to the target system.
An inspection rule with the same description/name may already exist in
the target system.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

INCLUDE QIE_ADMIN OBJECT DOKU ID TX

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QIE_COMMON015 - Table &1: Error in inspection rule with GUID &2 from the source system ?

  The SAP error message QIE_COMMON015 typically indicates that there is an issue with an inspection rule in the Quality Management (QM) module. This error can occur when the system is trying to access or process an inspection rule that is either missing, incorrectly configured, or has some inconsistencies in the source system.
  Cause:
  
  Missing Inspection Rule: The inspection rule identified by the GUID in the error message may not exist in the target system.
  Inconsistent Data: There may be inconsistencies or corruption in the data related to the inspection rule in the source system.
  Transport Issues: If the inspection rule was transported from one system to another, there may have been issues during the transport process.
  Authorization Issues: The user may not have the necessary authorizations to access the inspection rule.
  Configuration Issues: The configuration settings for Quality Management may not be correctly set up.
  
  Solution:
  
  Check the Inspection Rule: Verify that the inspection rule with the specified GUID exists in the source system. You can do this by using transaction codes like QG01 (Create Inspection Plan) or QG02 (Change Inspection Plan) to check if the rule is present.
  Data Consistency Check: Run consistency checks on the data in the source system to ensure that there are no inconsistencies or corruption.
  Transport Logs: If the inspection rule was recently transported, check the transport logs for any errors or warnings that may indicate issues during the transport process.
  Authorization Check: Ensure that the user has the necessary authorizations to access the inspection rule. You can check this using transaction SU53 to see if there are any authorization failures.
  Configuration Review: Review the configuration settings in the Quality Management module to ensure everything is set up correctly.
  Recreate the Inspection Rule: If the inspection rule is missing or corrupted, you may need to recreate it in the target system.
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as QG01, QG02, QG03 (Display Inspection Plan), and QA32 (Change Inspection Lot).
  SAP Notes: Check the SAP Support Portal for any relevant SAP Notes that may address this specific error message or provide additional troubleshooting steps.
  Documentation: Review the SAP documentation for Quality Management to understand how inspection rules are structured and managed.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP Basis or QM functional team for further assistance.