How To Fix QHU009 - You cannot have a single-unit inspection and HU inspection lots

QHU009 - Overview

• Message type: E = Error

• Message class: QHU - QM messages for processing inspection lots with HU's

• Message number: 009

• Message text: You cannot have a single-unit inspection and HU inspection lots

What causes this issue?

You set both the "Inspection for handling unit" and "Single-unit
inspection indicator". The system does not support
a single-unit inspection with handling units: The functions defined in
the documentation for the "Single-unit inspection" field are also not
supported with lots for handling units.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Cancel one of the indicators.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QHU009 - You cannot have a single-unit inspection and HU inspection lots ?

  The SAP error message QHU009 indicates that there is a conflict between the single-unit inspection and handling unit (HU) inspection lots. This error typically arises when you attempt to create an inspection lot for a handling unit that is set up for single-unit inspection, which is not allowed in the system.
  
  Cause:
  
  Single-Unit Inspection: The system is configured to perform inspections at the individual item level rather than at the handling unit level.
  Handling Unit Inspection Lot: The system is trying to create an inspection lot for a handling unit, which is incompatible with the single-unit inspection setting.
  Configuration Settings: The configuration settings in the Quality Management (QM) module may not be aligned with the handling unit management settings.
  
  
  Solution:
  To resolve the error, you can consider the following approaches:
  
  
  Change Inspection Type:
  
  If you need to perform inspections at the handling unit level, you may need to change the inspection type in the material master or the