How To Fix QE733 - No QM STI evaluation can be carried out for characteristic &1

SAP Error Message - Details

• Message type: E = Error

• Message class: QE - RM-QSS Fehlertexte zur Ergebniserfassung

• Message number: 733

• Message text: No QM STI evaluation can be carried out for characteristic &1

What causes this issue?

You tried to carry out a <ZH>QM-STI evaluation</> for characteristic
&V1&. To do so, the following preconditions must be fulfilled:
Confirmation of <ZH>measured values</> must be defined.
<ZH>Individual results</> must be defined.
At least one valid value must have been entered.

System Response

The function was not carried out.

How to fix this error?

Select a characteristic that fulfills the above preconditions.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QE733 - No QM STI evaluation can be carried out for characteristic &1 ?

  The SAP error message QE733 "No QM STI evaluation can be carried out for characteristic &1" typically occurs in the context of Quality Management (QM) when the system is unable to perform a Statistical Test Inspection (STI) evaluation for a specific characteristic. This can happen for several reasons, and understanding the cause is essential for resolving the issue.
  Causes:
  
  
  Characteristic Configuration: The characteristic in question may not be properly configured for statistical evaluation. This includes settings in the master data for the characteristic that may not allow for STI.
  
  
  Missing Data: There may be insufficient data available for the characteristic to perform the evaluation. This could be due to missing inspection lots or results.
  
  
  Incorrect Inspection Plan: The inspection plan associated with the characteristic may not be set up correctly, or the characteristic may not be included in the plan.
  
  
  Statistical Control Settings: The settings for statistical control in the quality management module may not be correctly defined, preventing the evaluation from being carried out.
  
  
  Characteristic Type: The characteristic type may not support statistical evaluations. For example, qualitative characteristics may not be suitable for STI.
  
  
  Solutions:
  
  
  Check Characteristic Configuration: Review the configuration of the characteristic in the Quality Management module. Ensure that it is set up for statistical evaluation and that all necessary parameters are defined.
  
  
  Verify Inspection Lots: Ensure that there are inspection lots available for the characteristic and that results have been recorded. If there are no results, the system cannot perform an evaluation.
  
  
  Review Inspection Plan: Check the inspection plan to ensure that the characteristic is included and that it is set up correctly for statistical evaluation.
  
  
  Adjust Statistical Control Settings: Review the statistical control settings in the QM module. Make sure that the settings allow for STI evaluations for the characteristic in question.
  
  
  Check Characteristic Type: Ensure that the characteristic type is appropriate for statistical evaluation. If it is a qualitative characteristic, consider whether it can be evaluated statistically.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on configuring characteristics for statistical evaluations.
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes such as QCC1 (Create Characteristic), QCC2 (Change Characteristic), or QCP1 (Create Inspection Plan) to review and modify the relevant settings.
  SAP Notes: Check for any relevant SAP Notes that may address known issues or provide additional guidance on this error message.
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the cause of the QE733 error and implement the necessary solutions to resolve it.