How To Fix QE614 - No mean value available for the measured values

SAP Error Message - Details

• Message type: E = Error

• Message class: QE - RM-QSS Fehlertexte zur Ergebniserfassung

• Message number: 614

• Message text: No mean value available for the measured values

What causes this issue?

The mean value of the valid measured values for the sample or the
inspection characteristic is missing. However, the procedure you
selected needs this value for the share estimate.

System Response

The shares of units that are too small, too large, or nonconforming
were not calculated.

How to fix this error?

Record valid measured values and enter the missing value, or it is
calculated internally by the system.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QE614 - No mean value available for the measured values ?

  The SAP error message QE614 ("No mean value available for the measured values") typically occurs in the context of quality management (QM) when you are trying to calculate or display mean values for a set of measured values, but the system cannot find any valid data to perform the calculation.
  Causes:
  
  No Measured Values: There may be no measured values recorded for the inspection lot or characteristic you are trying to analyze.
  Incorrect Data Entry: The measured values might not have been entered correctly, or they may have been deleted or not saved properly.
  Inspection Lot Status: The inspection lot may not be in a status that allows for mean value calculations (e.g., it might be in a status that prevents further processing).
  Characteristic Configuration: The characteristic may not be configured correctly to allow for mean value calculations.
  Data Type Issues: The data type of the measured values may not be compatible with the mean value calculation (e.g., text instead of numeric).
  
  Solutions:
  
  Check Measured Values: Verify that there are indeed measured values recorded for the inspection lot and characteristic in question. You can do this by navigating to the inspection lot and reviewing the recorded measurements.
  Re-enter Data: If you find that measured values are missing or incorrect, re-enter the necessary data and ensure it is saved properly.
  Review Inspection Lot Status: Check the status of the inspection lot to ensure it is open and allows for further processing. If it is closed or in a restricted status, you may need to change its status.
  Inspect Characteristic Configuration: Review the configuration of the characteristic in the quality management settings to ensure it is set up to allow mean value calculations.
  Data Type Validation: Ensure that the measured values are of the correct data type (e.g., numeric) and that they meet any other requirements for mean value calculations.
  
  Related Information:
  
  Transaction Codes: You may use transaction codes like QA32 (for displaying inspection lots) or QE01 (for entering results) to manage and review inspection lots and their associated data.
  Quality Management Configuration: Familiarize yourself with the configuration settings in the Quality Management module, particularly those related to inspection characteristics and result recording.
  SAP Notes: Check for any relevant SAP Notes that may address specific issues or bugs related to this error message. You can search for notes in the SAP Support Portal.
  
  If the issue persists after checking these areas, it may be beneficial to consult with your SAP support team or a functional consultant who specializes in the Quality Management module for further assistance.