How To Fix QE276 - Defect class &1 is not defined

SAP Error Message - Details

• Message type: E = Error

• Message class: QE - RM-QSS Fehlertexte zur Ergebniserfassung

• Message number: 276

• Message text: Defect class &1 is not defined

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message QE276 - Defect class &1 is not defined ?

  The SAP error message QE276, which states "Defect class &1 is not defined," typically occurs in the context of Quality Management (QM) when you are trying to create or process a defect report, and the system cannot find the specified defect class.
  Cause:
  The error is usually caused by one of the following reasons:
  
  Missing Configuration: The defect class you are trying to use has not been defined in the system. This could be due to a configuration oversight during the setup of the Quality Management module.
  Incorrect Input: The defect class code you entered may be incorrect or misspelled.
  Authorization Issues: The user may not have the necessary authorizations to access the defect class.
  
  Solution:
  To resolve the QE276 error, you can take the following steps:
  
  
  Check Defect Class Configuration:
  
  Go to the transaction code SPRO to access the SAP Customizing Implementation Guide.
  Navigate to Quality Management > Quality Control > Defect Management > Define Defect Classes.
  Verify if the defect class you are trying to use is defined. If it is not, you will need to create it.
  
  
  
  Create a Defect Class:
  
  If the defect class is missing, you can create a new one in the same configuration area mentioned above. Ensure that you provide all necessary details and save your changes.
  
  
  
  Verify Input:
  
  Double-check the defect class code you are entering. Ensure that it matches exactly with what is defined in the system, including case sensitivity.
  
  
  
  Check Authorizations:
  
  Ensure that the user has the necessary authorizations to access and use the defect class. You may need to consult with your SAP security team to verify and adjust user roles if necessary.
  
  
  
  Testing:
  
  After making the necessary changes, try to recreate the defect report to see if the error persists.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as QM01 (Create Quality Notification) and QM02 (Change Quality Notification) where this error might occur.
  Documentation: Refer to SAP Help documentation for Quality Management to understand more about defect classes and their configuration.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  
  If the issue persists after following these steps, consider reaching out to your SAP support team for further assistance.