How To Fix QC081 - No version was found for profile &1 &2

SAP Error Message - Details

• Message type: E = Error

• Message class: QC - QM: Certificates

• Message number: 081

• Message text: No version was found for profile &1 &2

What causes this issue?

A version for certificate profile &V1&, certificate type &V2& has not
yet been created on the database.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message QC081 - No version was found for profile &1 &2 ?

  The SAP error message QC081 "No version was found for profile &1 &2" typically occurs in the context of Quality Management (QM) when the system is unable to find a specific version of a quality inspection profile that is referenced in a transaction. This can happen for various reasons, such as missing configuration, incorrect profile assignment, or issues with the versioning of the profiles.
  Causes:
  
  Missing Profile: The specified inspection profile does not exist in the system.
  Incorrect Version: The version of the inspection profile that is being referenced is not available or has not been created.
  Profile Assignment: The inspection profile may not be correctly assigned to the material or the inspection lot.
  Data Inconsistency: There may be inconsistencies in the master data or configuration settings related to the quality management module.
  
  Solutions:
  
  
  Check Profile Existence:
  
  Go to the transaction code QDP1 (for creating or changing inspection profiles) and verify if the profile with the specified name exists.
  Ensure that the profile is active and correctly configured.
  
  
  
  Verify Version:
  
  Check if the version of the profile is correctly specified. You can do this by reviewing the profile settings in the system.
  If necessary, create a new version of the profile or activate an existing one.
  
  
  
  Profile Assignment:
  
  Ensure that the inspection profile is correctly assigned to the relevant material master record. You can check this in the material master data (transaction code MM02).
  Navigate to the Quality Management view and verify the inspection profile assignment.
  
  
  
  Check Configuration:
  
  Review the configuration settings in the Quality Management module to ensure that everything is set up correctly.
  Use transaction code SPRO to access the configuration settings and verify the settings related to inspection profiles.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for additional guidance on managing inspection profiles and resolving related issues.
  
  
  
  Contact Support:
  
  If the issue persists after checking the above points, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  
  
  Related Information:
  
  
  Transaction Codes:
  
  QDP1: Create/Change Inspection Profile
  MM02: Change Material Master
  SPRO: SAP Reference IMG (Implementation Guide)
  
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  
  By following these steps, you should be able to identify the cause of the QC081 error and implement a solution to resolve it.