How To Fix QAM112 - No. of target systems for key mapping to object category &1 is not 1

SAP Error Message - Details

• Message type: E = Error

• Message class: QAM - General Message Class for Quality Issue Management

• Message number: 112

• Message text: No. of target systems for key mapping to object category &1 is not 1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message QAM112 - No. of target systems for key mapping to object category &1 is not 1 ?

  The SAP error message QAM112 indicates that there is an issue with the key mapping for a specific object category in the Quality Management (QM) module. The message states that the number of target systems for key mapping is not equal to 1, which means that the system is expecting a single target system for the specified object category, but it has found either none or multiple target systems.
  Cause:
  
  Incorrect Configuration: The key mapping for the object category may not be correctly configured in the system. This could happen if multiple target systems are defined for the same object category or if no target system is defined at all.
  Data Inconsistency: There may be inconsistencies in the data related to the object category, leading to the system being unable to determine a single target system.
  Transport Issues: If the configuration was transported from another system, there might have been issues during the transport process that led to incorrect or incomplete data.
  
  Solution:
  
  
  Check Configuration:
  
  Go to the configuration settings for key mapping in the Quality Management module.
  Verify that there is exactly one target system defined for the object category in question.
  If there are multiple entries, you will need to adjust the configuration to ensure that only one target system is specified.
  
  
  
  Review Object Category:
  
  Check the specific object category mentioned in the error message. Ensure that it is correctly set up and that all necessary mappings are in place.
  
  
  
  Data Consistency Check:
  
  Run consistency checks on the data related to the object category to identify any discrepancies that may be causing the issue.
  
  
  
  Transport Logs:
  
  If the configuration was recently transported, check the transport logs for any errors or warnings that may indicate issues with the transport process.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the specific object category and key mapping to ensure that all required settings are correctly implemented.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the configuration and data, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like SPRO (to access the configuration settings) or SE11 (to check the data dictionary) to investigate the issue further.
  SAP Notes: Look for relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Community Forums: SAP Community and other forums can be helpful for finding similar issues faced by other users and their solutions.
  
  By following these steps, you should be able to identify and resolve the cause of the QAM112 error message in your SAP system.