How To Fix PVS0C205 - Node type &1 allows only one variant of type &2

SAP Error Message - Details

• Message type: E = Error

• Message class: PVS0C - Customizing Product Variant Structure (PVS)

• Message number: 205

• Message text: Node type &1 allows only one variant of type &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message PVS0C205 - Node type &1 allows only one variant of type &2 ?

  The SAP error message PVS0C205 indicates that there is an issue with the configuration of a node type in a variant configuration scenario. Specifically, it means that the node type specified (denoted as &1) is set up to allow only one variant of a certain type (denoted as &2), but the system is encountering a situation where multiple variants are being attempted.
  Cause:
  
  Node Type Configuration: The node type in question is configured to allow only a single variant of a specific type. This could be due to the way the variant configuration is set up in the SAP system.
  Multiple Selections: The error may occur if the user is trying to select multiple variants for a characteristic that is restricted to a single selection.
  Incorrect Model Setup: The model or configuration profile may not be set up correctly, leading to conflicts in variant selection.
  
  Solution:
  
  Review Node Type Configuration: Check the configuration of the node type in the variant configuration model. Ensure that it is set up correctly to allow the intended number of variants.
  Limit Selections: If the node type is indeed meant to allow only one variant, ensure that the user is only selecting one variant at a time. This may involve adjusting the user interface or providing guidance to users.
  Adjust Model Settings: If the requirement is to allow multiple variants, consider changing the configuration settings of the node type to allow for multiple selections, if applicable.
  Check Dependencies: Review any dependencies or constraints that may be affecting the selection of variants. Ensure that they are correctly defined and do not conflict with the node type settings.
  Testing: After making changes, test the configuration to ensure that the error no longer occurs and that the desired functionality is achieved.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CU01 (Create Configuration Profile) or CU02 (Change Configuration Profile) to access and modify the configuration settings.
  Documentation: Refer to SAP documentation on variant configuration for detailed information on node types, characteristics, and dependencies.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on variant configuration issues.
  
  If the problem persists after following these steps, it may be beneficial to consult with an SAP expert or reach out to SAP support for further assistance.