How To Fix PPEDI_XPR005 - The created iPPE node &1 &4 has no application data

SAP Error Message - Details

• Message type: E = Error

• Message class: PPEDI_XPR - DI System-Specific XPRA Messages for iPPE

• Message number: 005

• Message text: The created iPPE node &1 &4 has no application data

What causes this issue?

You have started the XPRA program PPE_XPRA_AUTO20_ECC_DIMP500. In this
conversion program, the system converts the APO resources into
proxy objects and iPPE resource nodes. This error message appears if
there are data inconsistencies that occur when an APO resource is
converted. The system could not completely create the resource nodes.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

How to fix this error?

Correct the database errors and start report &v2& again manually. No
more errors should occur. If the error occurs again, create a problem
message under component
LO-MD-PPE-FLO.
The data inconsistencies can be analyzed and corrected with the program
PNRES_CONSISTENCY_CHECK. Details about the program are included in
the program as comments.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPEDI_XPR005 - The created iPPE node &1 &4 has no application data ?

  The SAP error message PPEDI_XPR005 indicates that the created iPPE (Integrated Product and Process Engineering) node has no application data associated with it. This typically occurs when there is an attempt to create or manipulate a node in the iPPE structure, but the necessary data or configuration for that node is missing.
  Cause:
  
  Missing Data: The node being created may not have the required application data (like characteristics, values, or other relevant information) defined in the system.
  Incorrect Configuration: There may be an issue with the configuration of the iPPE model or the way the node is being defined.
  Data Inconsistency: There could be inconsistencies in the data that prevent the application from recognizing the node as valid.
  Authorization Issues: Sometimes, the user may not have the necessary authorizations to access or create the required data.
  
  Solution:
  
  Check Node Definition: Ensure that the node you are trying to create has all the necessary application data defined. This includes checking the characteristics and values that should be associated with the node.
  Review Configuration: Go through the iPPE configuration settings to ensure that everything is set up correctly. This includes checking the model structure and ensuring that all required components are in place.
  Data Validation: Validate the data being used to create the node. Make sure that there are no missing or incorrect entries that could lead to this error.
  Authorization Check: Verify that the user has the necessary permissions to create and manipulate iPPE nodes. If not, contact your system administrator to obtain the required authorizations.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidelines on iPPE node creation and the required data structure.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  iPPE Documentation: Review the iPPE documentation for best practices on node creation and data management.
  Community Forums: Engage with SAP community forums or support channels where similar issues may have been discussed, and solutions shared.
  
  If the issue persists after following these steps, it may be beneficial to reach out to SAP support for further assistance, providing them with detailed information about the error and the context in which it occurs.