How To Fix PPEDI_CMPID004 - Unit &1 is not valid for the material &2

SAP Error Message - Details

• Message type: E = Error

• Message class: PPEDI_CMPID - Messages for Material in iPPE

• Message number: 004

• Message text: Unit &1 is not valid for the material &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPEDI_CMPID004 - Unit &1 is not valid for the material &2 ?

  The SAP error message PPEDI_CMPID004 indicates that the unit of measure (UoM) specified for a material is not valid. This error typically occurs in the context of production planning or inventory management when the system cannot recognize the unit of measure associated with the material in question.
  Cause:
  
  Invalid Unit of Measure: The unit of measure specified for the material does not exist in the system or is not defined correctly.
  Material Master Configuration: The material master record may not have the correct unit of measure assigned or may be missing necessary configurations.
  Unit of Measure Conversion: There may be issues with the conversion factors between different units of measure, leading to the system not recognizing the specified unit.
  Data Entry Error: There could be a typographical error in the unit of measure entered during the transaction.
  
  Solution:
  
  
  Check Material Master:
  
  Go to the material master record (transaction code MM03).
  Verify that the unit of measure is correctly defined in the Basic Data view and the Purchasing view.
  Ensure that the unit of measure is valid and active.
  
  
  
  Review Unit of Measure Settings:
  
  Check the configuration of units of measure in the system (transaction code OMU1 for defining units of measure).
  Ensure that the unit of measure is defined in the system and is linked to the material.
  
  
  
  Correct Data Entry:
  
  If the error is due to a data entry mistake, correct the unit of measure in the transaction where the error occurred.
  
  
  
  Check Conversion Factors:
  
  If applicable, review the conversion factors between different units of measure to ensure they are set up correctly.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for additional guidance on unit of measure issues.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: 
  
  MM03 - Display Material
  MM02 - Change Material
  OMU1 - Define Units of Measure
  
  
  SAP Notes: Check for any relevant SAP Notes that may address specific issues related to this error message.
  User Roles: Ensure that the user has the necessary permissions to view and edit material master data.
  
  By following these steps, you should be able to identify and resolve the issue related to the PPEDI_CMPID004 error message in SAP.