How To Fix PPECMP307 - Unit &1 can have a maximum of &2 decimal place(s)

PPECMP307 - Overview

• Message type: E = Error

• Message class: PPECMP - Messages for iPPE CMP Application (Components)

• Message number: 307

• Message text: Unit &1 can have a maximum of &2 decimal place(s)

What causes this issue?

The maximum number of decimal places (&v2&) has been exceeded for unit
&v1&.

System Response

The system allows a maximum of &v2& decimal places for the specified
unit &v1&.

How to fix this error?

Specify a quantity with a maximum of &v2& decimal places.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPECMP307 - Unit &1 can have a maximum of &2 decimal place(s) ?

  The SAP error message PPECMP307 indicates that there is a restriction on the number of decimal places allowed for a specific unit of measure (UoM) in the system. This error typically occurs when you are trying to enter a quantity or value that exceeds the defined limit for decimal places for that unit.
  
  Cause:
  The error is triggered when:
  
  You attempt to enter a value with more decimal places than what is allowed for the specified unit of measure.
  The unit of measure configuration in the system has a defined maximum number of decimal places, and the input exceeds this limit.
  
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Unit of Measure Configuration:
  
  Go to the transaction code CUNI (Unit of Measure Conversion) or OMN1 (Define Units of Measure) in SAP.
  Look for the specific unit of measure that is causing the error and check its configuration.
  Verify the maximum number of decimal places allowed