How To Fix PPEBAL142 - &1 in line balance rate &2 is not a unit of time

SAP Error Message - Details

• Message type: E = Error

• Message class: PPEBAL - Line Balance Message

• Message number: 142

• Message text: &1 in line balance rate &2 is not a unit of time

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPEBAL142 - &1 in line balance rate &2 is not a unit of time ?

  The SAP error message PPEBAL142 indicates that there is an issue with the line balance rate specified in the system. Specifically, the error message states that the line balance rate (denoted as &2) is not recognized as a unit of time. This typically occurs in the context of production planning or line balancing scenarios within SAP.
  Cause:
  
  Incorrect Configuration: The line balance rate may have been incorrectly configured in the system. It should be defined in a time unit (e.g., hours, minutes) but is instead set to a different unit (e.g., pieces, units).
  Data Entry Error: There may have been a mistake during data entry where a non-time unit was entered for the line balance rate.
  Master Data Issues: The master data related to the production line or work center may not be set up correctly, leading to this error.
  
  Solution:
  
  
  Check Configuration:
  
  Navigate to the configuration settings for line balancing in SAP.
  Ensure that the line balance rate is defined using a valid time unit. You can do this by going to the relevant configuration transaction (e.g., SPRO) and checking the settings under Production Planning.
  
  
  
  Review Master Data:
  
  Check the master data for the work center or production line where the error occurred.
  Ensure that the line balance rate is set correctly and is using a time unit.
  
  
  
  Correct Data Entry:
  
  If the error is due to incorrect data entry, correct the line balance rate in the relevant transaction (e.g., in the work center or production line settings).
  Make sure to save the changes and recheck if the error persists.
  
  
  
  Testing:
  
  After making the necessary corrections, test the process again to ensure that the error no longer appears.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CR01 (Create Work Center), CR02 (Change Work Center), or PPC1 (Line Balancing) to access the relevant settings.
  Documentation: Refer to SAP documentation or help files for more detailed information on configuring line balance rates and understanding the units of measure used in production planning.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on resolving it.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a functional consultant who specializes in production planning.