How To Fix PPEACT703 - Inconsistency in mode linkage between &1 and &2 at mode &3

SAP Error Message - Details

• Message type: E = Error

• Message class: PPEACT - Messages for iPPE ACT Application (Activities)

• Message number: 703

• Message text: Inconsistency in mode linkage between &1 and &2 at mode &3

What causes this issue?

To create a mode linkage using a mode number, the activity modes must
have the same mode numbers. This is required for the entire routing
validity period. However, this is not the case for all
change statuses of the modes.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

How to fix this error?

Ensure that all modes for both activities use the same mode number
in the entire routing validity period.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPEACT703 - Inconsistency in mode linkage between &1 and &2 at mode &3 ?

  The SAP error message PPEACT703 indicates an inconsistency in mode linkage between two modes in the context of production planning or variant configuration. This error typically arises when there is a mismatch or inconsistency in the mode definitions or their relationships in the system.
  Cause:
  The error can occur due to several reasons, including:
  
  Incorrect Mode Configuration: The modes defined in the system may not be correctly linked or may have been altered without proper updates to related modes.
  Missing or Incorrect Dependencies: There may be missing dependencies or incorrect settings in the mode linkage that lead to inconsistencies.
  Data Corruption: In some cases, data corruption or inconsistencies in the database can lead to this error.
  Changes in Master Data: Changes in the master data related to the modes may not have been properly propagated, leading to inconsistencies.
  
  Solution:
  To resolve the PPEACT703 error, you can follow these steps:
  
  
  Check Mode Definitions: Review the mode definitions for the involved modes (&1, &2, and &3) to ensure they are correctly configured and linked. Look for any discrepancies in the settings.
  
  
  Validate Dependencies: Ensure that all dependencies between the modes are correctly defined. This includes checking for any missing or incorrect entries in the mode linkage.
  
  
  Recreate Mode Linkage: If you find inconsistencies, you may need to recreate the mode linkage. This can involve deleting the existing linkage and setting it up again correctly.
  
  
  Use Transaction Codes: Utilize relevant transaction codes such as CU50 (for configuration) or C223 (for mode management) to check and adjust the configurations.
  
  
  Check for Notes and Patches: Look for any SAP Notes or patches that may address this specific error. Sometimes, SAP releases updates that fix known issues.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for detailed guidance on mode linkage and configuration.
  
  
  Contact SAP Support: If the issue persists after trying the above steps, consider reaching out to SAP support for further assistance. Provide them with the error message details and any steps you have already taken.
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with transaction codes related to variant configuration and mode management, such as CU50, C223, and C220.
  SAP Notes: Regularly check the SAP Support Portal for notes related to production planning and variant configuration issues.
  Training and Documentation: Consider training sessions or documentation on variant configuration and mode management to better understand the system's workings.
  
  By following these steps, you should be able to identify and resolve the inconsistency causing the PPEACT703 error.