How To Fix PPEACT551 - Reporting point at &1 &2 must be constant for all change statuses

PPEACT551 - Overview

• Message type: E = Error

• Message class: PPEACT - Messages for iPPE ACT Application (Activities)

• Message number: 551

• Message text: Reporting point at &1 &2 must be constant for all change statuses

What causes this issue?

Different reporting points were assigned to several change statuses
at &v1& &v2&. This leads to problems during backflush.

System Response

How to fix this error?

Assign the same reporting point to all change statuses of mode
&v1& &v2&.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PPEACT551 - Reporting point at &1 &2 must be constant for all change statuses ?

  The SAP error message PPEACT551 indicates that there is an issue with the reporting point in a production planning or process order context. Specifically, it states that the reporting point at the specified location (indicated by &1 and &2) must be constant for all change statuses. This typically occurs in scenarios where the reporting point is expected to remain the same across different statuses of a production order or process order, but it has been found to vary.
  
  Cause:
  
  Inconsistent Reporting Points: The reporting point defined for the order may have been changed or is inconsistent across different statuses of the order.
  
  Configuration Issues: There may be configuration settings in the system that do not align with the expected behavior of reporting points.
  Data Entry Errors: Manual data entry errors during the creation or modification of the order can lead to discrepancies in reporting points.
  Process Flow Issues: The process flow defined in the system