How To Fix PMEVC_UI033 - Plant & is not identical to the one of the model

SAP Error Message - Details

• Message type: E = Error

• Message class: PMEVC_UI -

• Message number: 033

• Message text: Plant & is not identical to the one of the model

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message PMEVC_UI033 - Plant & is not identical to the one of the model ?

  The SAP error message PMEVC_UI033 typically occurs in the context of SAP Variant Configuration (VC) when there is a mismatch between the plant specified in the configuration and the plant associated with the model or configurable material. This error can arise during the configuration of a product variant when the system expects the plant to be consistent across the configuration.
  Cause:
  
  Plant Mismatch: The plant specified in the configuration does not match the plant defined for the model or the base material.
  Incorrect Configuration: The user may have selected a different plant while configuring the variant than the one associated with the model.
  Master Data Issues: There may be inconsistencies in the master data setup, such as the plant not being assigned correctly to the model or the configuration not being set up for the selected plant.
  
  Solution:
  
  
  Check Plant Assignment:
  
  Verify that the plant assigned in the configuration matches the plant defined for the model. You can do this by checking the material master data and the configuration settings.
  
  
  
  Correct Configuration:
  
  If the plant is incorrect, re-select the correct plant that corresponds to the model you are trying to configure.
  
  
  
  Review Master Data:
  
  Ensure that the model and its variants are correctly set up in the system. Check the configuration profiles and ensure that the plant is correctly assigned.
  If necessary, update the master data to ensure consistency.
  
  
  
  Consult Documentation:
  
  Review any relevant SAP documentation or notes related to Variant Configuration and plant assignments to ensure compliance with best practices.
  
  
  
  User Training:
  
  If users are frequently encountering this error, consider providing additional training on how to properly configure products in SAP VC, emphasizing the importance of plant selection.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like MM02 (Change Material), CU50 (Configuration Profile), or CS03 (Display Material BOM) to check and modify the relevant data.
  SAP Notes: Check for any SAP Notes that may address specific issues related to this error message or provide additional guidance.
  Support: If the issue persists after checking the above points, consider reaching out to your SAP support team for further assistance.
  
  By following these steps, you should be able to resolve the PMEVC_UI033 error and ensure that the plant assignments are consistent across your configuration.