How To Fix /PLMI/RCA_CALC037 - Unit &1 is not of dimension &2; density cannot be calculated

SAP Error Message - Details

• Message type: E = Error

• Message class: /PLMI/RCA_CALC -

• Message number: 037

• Message text: Unit &1 is not of dimension &2; density cannot be calculated

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /PLMI/RCA_CALC037 - Unit &1 is not of dimension &2; density cannot be calculated ?

  The SAP error message /PLMI/RCA_CALC037 Unit &1 is not of dimension &2; density cannot be calculated typically occurs in the context of SAP's Product Lifecycle Management (PLM) or related modules where density calculations are performed. This error indicates that there is a mismatch between the unit of measure (UoM) being used and the expected dimension for density calculations.
  Cause:
  
  Unit of Measure Mismatch: The unit of measure (UoM) assigned to the material or component does not match the expected dimension for density calculations. For example, if the system expects a mass unit (like kilograms) but receives a volume unit (like liters), it will trigger this error.
  Incorrect Configuration: The configuration settings for the material or the density calculation may not be set up correctly, leading to the system not recognizing the unit of measure.
  Data Entry Errors: There may be errors in the data entry for the material master or the specific transaction where the density is being calculated.
  
  Solution:
  
  Check Unit of Measure: Verify the unit of measure assigned to the material. Ensure that it is appropriate for density calculations (e.g., mass units like kg or g for density).
  Review Material Master Data: Go to the material master data and check the settings related to the unit of measure and density. Ensure that the density is defined correctly and that the units are compatible.
  Adjust Configuration: If necessary, adjust the configuration settings in the system to ensure that the expected dimensions for density calculations are correctly defined.
  Consult Documentation: Refer to SAP documentation or help resources for guidance on the specific requirements for density calculations in your version of SAP.
  Test with Different Units: If possible, test the calculation with different units of measure to see if the error persists. This can help identify if the issue is specific to a certain unit.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Forums: Look for discussions in SAP community forums or user groups where similar issues may have been resolved.
  SAP Help Portal: Utilize the SAP Help Portal for detailed information on the PLM module and density calculations.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a technical consultant who can provide more in-depth analysis and assistance.