How To Fix /PLMI/BO_RCA_OPT033 - Item &1 is a secondary output; upper limit cannot be greater than 0

SAP Error Message - Details

• Message type: E = Error

• Message class: /PLMI/BO_RCA_OPT -

• Message number: 033

• Message text: Item &1 is a secondary output; upper limit cannot be greater than 0

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /PLMI/BO_RCA_OPT033 - Item &1 is a secondary output; upper limit cannot be greater than 0 ?

  The SAP error message /PLMI/BO_RCA_OPT033 Item &1 is a secondary output; upper limit cannot be greater than 0 typically occurs in the context of production planning or process management within SAP, particularly when dealing with production orders or process orders that involve secondary outputs.
  Cause:
  This error indicates that you are trying to set an upper limit for a secondary output item (in this case, item &1) that is greater than zero. In SAP, secondary outputs are typically by-products or co-products that are produced alongside the main product. The system does not allow you to set an upper limit for these secondary outputs because they are not the primary focus of the production process.
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check the Item Configuration: 
  
  Go to the configuration of the item in question (item &1) and verify its settings. Ensure that it is correctly defined as a secondary output.
  
  
  
  Adjust the Upper Limit:
  
  If you have mistakenly set an upper limit for the secondary output, you need to change this value to 0 or remove the upper limit entirely. This can usually be done in the production order or process order where the item is defined.
  
  
  
  Review Production Order Settings:
  
  Check the production order or process order settings to ensure that the secondary output is configured correctly. Make sure that the main product and secondary outputs are defined according to your production process.
  
  
  
  Consult Documentation:
  
  If you are unsure about the configuration, refer to the SAP documentation or help resources related to production planning and secondary outputs.
  
  
  
  Seek Help from SAP Support:
  
  If the issue persists after checking the configuration and settings, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  
  
  Related Information:
  
  Secondary Outputs: In SAP, secondary outputs are typically used in scenarios where by-products are generated during the production process. They are not the main focus of the production and usually do not have upper limits set.
  Production Orders: Understanding how production orders are structured in SAP can help in troubleshooting issues related to outputs and limits.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional guidance on handling secondary outputs.
  
  By following these steps, you should be able to resolve the error and ensure that your production process is configured correctly.