How To Fix /PLMB/BA_MCH022 - Mass change function was not created

SAP Error Message - Details

• Message type: E = Error

• Message class: /PLMB/BA_MCH -

• Message number: 022

• Message text: Mass change function was not created

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message /PLMB/BA_MCH022 - Mass change function was not created ?

  The SAP error message /PLMB/BA_MCH022 indicates that the mass change function for a specific operation or transaction was not created. This error typically arises in the context of SAP PLM (Product Lifecycle Management) or related modules where mass changes to data are expected but have not been configured or enabled.
  Cause:
  
  Missing Configuration: The mass change function may not have been set up in the system. This could be due to a lack of necessary configuration in the customizing settings.
  Authorization Issues: The user may not have the required authorizations to execute mass changes.
  System Limitations: The specific transaction or object type may not support mass changes due to system limitations or design.
  Incorrect Transaction Code: The transaction code being used may not be the correct one for the intended mass change operation.
  
  Solution:
  
  
  Check Configuration:
  
  Navigate to the relevant customizing settings in SAP (usually through SPRO) and verify if the mass change function has been defined for the specific object type you are working with.
  Ensure that the necessary settings for mass changes are activated.
  
  
  
  Review Authorizations:
  
  Check the user roles and authorizations to ensure that the user has the necessary permissions to perform mass changes.
  If needed, consult with your SAP security team to adjust the roles.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help files related to the specific module you are working with to understand if mass changes are supported and how to enable them.
  
  
  
  Use Correct Transaction:
  
  Ensure that you are using the correct transaction code for the mass change operation. If unsure, consult with your SAP functional consultant or refer to the documentation.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. They may provide insights specific to your system configuration or version.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error message or provide additional troubleshooting steps.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  Training and Documentation: Ensure that users are trained on the correct procedures for performing mass changes in SAP to avoid configuration or usage errors.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.