How To Fix PLM_FMEA_APPL606 - A maximum of two valuation profiles are permitted per axis definition

PLM_FMEA_APPL606 - Overview

• Message type: E = Error

• Message class: PLM_FMEA_APPL - FMEA - Message

• Message number: 606

• Message text: A maximum of two valuation profiles are permitted per axis definition

What causes this issue?

No more than two valuation profiles per definition of an axis (X-axis or
Y-axis) can be assigned to a risk matrix. When you assign two valuation
profiles to the axis definition, the respective axis of the risk matrix
receives all values that result from the possible multiplications of the
values from the two valuation profiles.

System Response

The action was canceled.

How to fix this error?

Assign a maximum of two valuation profiles to the definition of the
axis.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PLM_FMEA_APPL606 - A maximum of two valuation profiles are permitted per axis definition ?

  The SAP error message PLM_FMEA_APPL606 indicates that there is an issue with the configuration of valuation profiles in the context of Failure Mode and Effects Analysis (FMEA) within the SAP PLM (Product Lifecycle Management) module. Specifically, this error arises when more than two valuation profiles are defined for a single axis in the FMEA configuration.
  
  Cause:
  The error is triggered when the system detects that more than two valuation profiles have been assigned to a single axis definition in the FMEA setup. In FMEA, valuation profiles are used to assess the severity, occurrence, and detection of potential failure modes, and the system restricts the number of profiles to ensure clarity and manageability.
  
  Solution:
  To resolve this error, you need to review and adjust the configuration of the valuation profiles associated with the axis definitions in your FMEA setup. Here are the steps you can take:
  
  
  Access FMEA Configuration:
  
  Navigate to the FMEA configuration settings in your