How To Fix PB150 - No current planning cycle has been set

SAP Error Message - Details

• Message type: E = Error

• Message class: PB - PD: Message IDs Org. Management

• Message number: 150

• Message text: No current planning cycle has been set

What causes this issue?

No current planning status has been set for headcount planning.

How to fix this error?

Set a current planning status (table T77POSBUD).

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message PB150 - No current planning cycle has been set ?

  The SAP error message PB150 "No current planning cycle has been set" typically occurs in the context of SAP's planning and budgeting modules, such as SAP Business Planning and Consolidation (BPC) or SAP Integrated Business Planning (IBP). This error indicates that the system cannot find an active planning cycle for the user or the specific planning area being accessed.
  Cause:
  
  No Active Planning Cycle: The most common cause is that there is no planning cycle defined or activated for the current period or context in which the user is trying to perform planning activities.
  User Authorization: The user may not have the necessary authorizations to access the planning cycle.
  Configuration Issues: There may be configuration issues in the planning area or planning version that prevent the system from recognizing the current planning cycle.
  Incorrect Settings: The settings in the planning application or the user profile may not be correctly configured to point to an active planning cycle.
  
  Solution:
  
  
  Check Planning Cycle:
  
  Go to the planning area or application and verify if a planning cycle is defined and active for the period you are trying to access.
  Ensure that the planning cycle is correctly set up in the system.
  
  
  
  Set Current Planning Cycle:
  
  If you have the necessary permissions, you can set the current planning cycle in the relevant planning application or transaction.
  This can usually be done in the planning settings or configuration area.
  
  
  
  User Authorizations:
  
  Check if the user has the necessary authorizations to access the planning cycle. If not, contact your SAP security administrator to grant the required permissions.
  
  
  
  Configuration Review:
  
  Review the configuration settings for the planning area or version to ensure they are correctly set up.
  Consult with your SAP Basis or configuration team if you suspect there are issues with the setup.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific instructions related to your version of SAP and the planning module you are using.
  
  
  
  Contact Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: Depending on the specific SAP module, you may use transaction codes like KP06 (Cost Center Planning) or CNS0 (Planning Area) to check planning cycles.
  SAP Notes: Look for relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Forums: SAP Community forums can be a valuable resource for finding solutions from other users who have encountered similar issues.
  
  By following these steps, you should be able to identify and resolve the issue related to the PB150 error message in SAP.