How To Fix OIURR083 - OGOR C volume rounding out of tolerance: Lse/Agr &, MMS PdCd &, & Amt &.

OIURR083 - Overview

• Message type: E = Error

• Message class: OIURR - Production Regulatory Reporting

• Message number: 083

• Message text: OGOR C volume rounding out of tolerance: Lse/Agr &, MMS PdCd &, & Amt &.

What causes this issue?

OGOR C Production Volumes are reconciled against OGOR B
Produced-Into-Inventory-Prior-to-Sales Volumes. The total OGOR C Pro
duction per lease should equal the total OGOR B Produced into Inventory
per lease. If it does not, the OGOR C Production Volume is adjusted as
such. Normally these adjustments will be made due to rounding errors,
so the amount should be relatively small. This warning occurred
because the OGOR C Production adjustment was outside the acceptable
tolerance, where "acceptable tolerance" is determined by taking the
Adjustment divided by the Original OGOR C Production Volume and
comparing that to the Rounding Tolerance Percentage setup in cust
omizing. If the adjustment percent is larger than the rounding
tolerance percent, this warning message is issued.

System Response

The program will continue to make the adjustment to OGOR C Production
volume, but issue this warning message to flag the customer that a
large adjustment was made.

How to fix this error?

There are 2 possible causes/solutions:
(1),,Cause 1:,,The OGOR C / OGOR B "Major Product / Volume Type to MMS
Code" mapping is incorrect or incomplete for the OGOR B and/or the OGOR
C.
,,Solution:,,Go into the IMG customizing for "MMS Specific Settings"
and correct the OGOR B or OGOR C customizing:
,,Cross Referencing MajPdCd, VT to MMS Codes (OGOR B) or
,,Cross Referencing MajPdCd, VT to MMS Codes (OGOR C)
(2),,Cause 2:,,The Rounding Tolerance Percentage is set too low.
,,Solution: ,,Go into the IMG customizing for "Regulatory Reporting
Master Data Setup" and Raise the Tolerance percent in the "OGOR" report
"Reporting Level" configuration.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message OIURR083 - OGOR C volume rounding out of tolerance: Lse/Agr &, MMS PdCd &, & Amt &. ?

  The SAP error message OIURR083 indicates that there is a rounding issue with the volume of a product in a specific transaction, typically related to the Oil and Gas industry. This error often arises in the context of volume calculations for transactions involving leases, agreements, or product deliveries.
  
  Cause:
  
  Rounding Tolerance: The error suggests that the calculated volume is outside the acceptable rounding tolerance defined in the system. This can happen if the volume is not a whole number or if the decimal places exceed the defined limits.
  
  Configuration Issues: The rounding rules or tolerances may not be properly configured in the system, leading to discrepancies in volume calculations.
  Data Entry Errors: Incorrect data entry in the relevant fields (like lease agreements or product codes) can lead to unexpected volume calculations.
  System Bugs: Occasionally, software bugs or issues in the version of SAP being used can lead to such errors.
  
  
  Solution:
  
  Check Rounding Configuration: Review the rounding