How To Fix OIUPR858 - At least one well exists upstream of multiple Measurement Pts in network.

SAP Error Message - Details

• Message type: E = Error

• Message class: OIUPR - PRA Production Messages

• Message number: 858

• Message text: At least one well exists upstream of multiple Measurement Pts in network.

What causes this issue?

At least one well exists under multiple Measurement Points.

System Response

This message is for informational purposes only.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message OIUPR858 - At least one well exists upstream of multiple Measurement Pts in network. ?

  The SAP error message OIUPR858, which states "At least one well exists upstream of multiple Measurement Pts in network," typically occurs in the context of SAP's Oil and Gas (Upstream) module, particularly when dealing with the configuration of measurement points and their relationships to wells in a network.
  Cause:
  This error usually arises when there is a configuration issue in the network of measurement points and wells. Specifically, it indicates that there are multiple measurement points that are linked to a single well, but the system is unable to determine the correct upstream flow path due to the way these points are configured. This can happen if:
  
  Multiple Measurement Points: There are multiple measurement points that are incorrectly configured to reference the same well.
  Network Configuration: The network configuration does not properly define the flow relationships between wells and measurement points.
  Data Integrity Issues: There may be inconsistencies or errors in the master data related to wells and measurement points.
  
  Solution:
  To resolve the OIUPR858 error, you can take the following steps:
  
  
  Review Measurement Point Configuration:
  
  Check the configuration of the measurement points in the system. Ensure that each measurement point is correctly linked to its respective well and that there are no duplicate references.
  
  
  
  Check Well Configuration:
  
  Verify the configuration of the wells in the system. Ensure that each well is correctly defined and that it does not have conflicting relationships with multiple measurement points.
  
  
  
  Network Analysis:
  
  Analyze the network configuration to ensure that the flow paths are correctly defined. You may need to adjust the network to ensure that each measurement point has a clear and unique upstream well.
  
  
  
  Data Consistency Check:
  
  Perform a data consistency check to identify any discrepancies in the master data. This may involve running reports or using tools within SAP to validate the relationships between wells and measurement points.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources specific to the Oil and Gas module for additional guidance on configuring measurement points and wells.
  
  
  
  Engage Technical Support:
  
  If the issue persists after checking the configurations, consider reaching out to SAP support or your internal IT team for further assistance. They may have additional tools or insights to help resolve the issue.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Training and Documentation: Review training materials or documentation related to the configuration of measurement points and wells in SAP.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify and resolve the underlying cause of the OIUPR858 error in your SAP system.