How To Fix OIUPR708 - The total volume at the listed MP was not allocated to all fun's

SAP Error Message - Details

• Message type: E = Error

• Message class: OIUPR - PRA Production Messages

• Message number: 708

• Message text: The total volume at the listed MP was not allocated to all fun's

What causes this issue?

The quantity given is the amount that was allocated to furtherst
upstream nodes.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Use transaction o3u_dnap3 to check the auto flow checkbox for the
listed material/vt. If the autoflow checkbox is not checked, an
allocation profile has to be set up at the upstream MP's through which
the listed material/vt can flow. MP Allocation Profiles can be setup
using o3u_mpap1.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message OIUPR708 - The total volume at the listed MP was not allocated to all fun's ?

  The SAP error message OIUPR708 indicates that there is an issue with the allocation of total volume at a specific measurement point (MP) to all relevant funds. This error typically arises in the context of SAP's Oil and Gas or Utilities modules, where volume allocations are critical for financial and operational reporting.
  Cause:
  
  Incomplete Allocation: The total volume recorded at the measurement point has not been fully allocated to all the funds that should receive a share of that volume.
  Configuration Issues: There may be configuration settings in the allocation process that are not set up correctly, leading to discrepancies in volume distribution.
  Data Entry Errors: Incorrect or incomplete data entry during the allocation process can result in volumes not being allocated properly.
  Missing Fund Assignments: The funds that should receive allocations may not be properly assigned to the measurement point in the system.
  
  Solution:
  
  Review Allocation Entries: Check the allocation entries for the measurement point in question. Ensure that the total volume is correctly allocated to all relevant funds.
  Adjust Configuration: If there are configuration issues, review the settings related to volume allocation in the SAP system. Make necessary adjustments to ensure that all funds are included in the allocation process.
  Correct Data Entry: If data entry errors are identified, correct the entries to ensure that the total volume is accurately reflected and allocated.
  Fund Assignment Verification: Verify that all necessary funds are assigned to the measurement point. If any funds are missing, add them to the configuration.
  Run Allocation Process Again: After making the necessary corrections, re-run the allocation process to ensure that the total volume is now correctly allocated.
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as OIUPR (for allocation processes) and OIUPR1 (for allocation run) to navigate the system effectively.
  Documentation: Refer to SAP documentation or help files related to volume allocation and fund management for detailed guidance on configuration and troubleshooting.
  Support: If the issue persists after attempting the above solutions, consider reaching out to your SAP support team or consulting with an SAP expert who specializes in the Oil and Gas or Utilities modules.
  
  By following these steps, you should be able to resolve the OIUPR708 error and ensure that total volumes are properly allocated to all relevant funds.