How To Fix OIUPR619 - FATAL: VOL CALC FORMULA SPECIFIED USE OF NON-EXISTING VOL FROM ANOTHR MP

SAP Error Message - Details

• Message type: E = Error

• Message class: OIUPR - PRA Production Messages

• Message number: 619

• Message text: FATAL: VOL CALC FORMULA SPECIFIED USE OF NON-EXISTING VOL FROM ANOTHR MP

What causes this issue?

A VOLUME CALCULATION FORMULA SPECIFIED THAT A VOLUME FROM ANOTHER
MEASUREMENT POINT SHOULD BE USED IN THE CALCULATION BUT THE VOLUME FROM
THE OTHER MEASUREMENT POINT WAS NOT FOUND OR COULD NOT BE CALCULATED

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message OIUPR619 - FATAL: VOL CALC FORMULA SPECIFIED USE OF NON-EXISTING VOL FROM ANOTHR MP ?

  The SAP error message OIUPR619 indicates that there is an issue with a volume calculation formula in the context of the SAP Oil and Gas (SAP OIL) module, specifically related to the use of a volume (VOL) from another measurement point (MP) that does not exist or is not defined correctly.
  Cause:
  
  Non-Existent Volume Reference: The formula specified in the volume calculation is referencing a volume that is not defined in the system or does not exist in the specified measurement point.
  Incorrect Measurement Point Configuration: The measurement point from which the volume is being referenced may not be set up correctly or may have been deleted.
  Formula Syntax Error: There may be a syntax error in the volume calculation formula that leads to the system being unable to resolve the reference to the volume.
  Data Consistency Issues: There may be inconsistencies in the data, such as missing entries or incorrect mappings between measurement points and volumes.
  
  Solution:
  
  Verify Measurement Points: Check the configuration of the measurement points involved in the volume calculation. Ensure that all referenced measurement points exist and are correctly set up.
  Check Volume Definitions: Ensure that the volumes being referenced in the formula are defined and active in the system. If a volume has been deleted or is inactive, it will lead to this error.
  Review the Formula: Examine the volume calculation formula for any syntax errors or incorrect references. Make sure that all components of the formula are valid and correctly reference existing volumes.
  Data Consistency Check: Perform a data consistency check to identify any discrepancies in the measurement point and volume data. Correct any inconsistencies found.
  Consult Documentation: Refer to SAP documentation or help resources for guidance on the specific volume calculation formulas and their requirements.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Transaction Codes: Familiarize yourself with relevant transaction codes in SAP for managing measurement points and volume calculations, such as OIUPR (for volume calculation) and OIUML (for measurement point management).
  User Forums and Communities: Engage with SAP user communities or forums where similar issues may have been discussed, and solutions shared.
  
  If the issue persists after following these steps, it may be beneficial to reach out to SAP support for further assistance.