How To Fix OIUPR380 - DN Alloc Seq 0 is not allowed with TCM = SW (Single WellCompletion )

SAP Error Message - Details

• Message type: E = Error

• Message class: OIUPR - PRA Production Messages

• Message number: 380

• Message text: DN Alloc Seq 0 is not allowed with TCM = SW (Single WellCompletion )

What causes this issue?

Sequence 0 in the Delivery Network Allocation Profile is not allowed
when the Theoretical Calculation Method for that major product is 'SW'
Single Well Completion.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message OIUPR380 - DN Alloc Seq 0 is not allowed with TCM = SW (Single WellCompletion ) ?

  The SAP error message OIUPR380 indicates that there is an issue with the allocation sequence in the context of a single well completion (SW) in the SAP system, particularly in the Oil and Gas industry module (often referred to as SAP IS-Oil). This error typically arises when there is a mismatch or an incorrect configuration related to the allocation sequence and the transaction control method (TCM).
  Cause:
  
  Incorrect Allocation Sequence: The allocation sequence specified (in this case, 0) is not valid for the transaction control method (SW) being used. This could be due to a configuration issue where the allocation sequence is not set up correctly for single well completions.
  Configuration Issues: The system may not be configured to handle the allocation sequence for the specific well completion type you are working with.
  Data Entry Errors: There may be errors in the data entry where the allocation sequence is incorrectly specified or not applicable for the given context.
  
  Solution:
  
  
  Check Allocation Sequence Configuration:
  
  Navigate to the configuration settings for allocation sequences in your SAP system.
  Ensure that the allocation sequence for single well completions is correctly defined and that it allows for the specified sequence (in this case, 0).
  
  
  
  Review Transaction Control Method:
  
  Verify that the transaction control method (TCM) is set correctly for the well completion you are working with. If it is set to SW, ensure that the allocation sequence is compatible with this method.
  
  
  
  Correct Data Entry:
  
  Review the data entry for the allocation sequence. Ensure that the correct sequence number is being used and that it aligns with the expected values for the TCM.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources specific to the IS-Oil module for guidance on allocation sequences and transaction control methods.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the configuration and data entry, consider reaching out to SAP support for further assistance. They may provide insights specific to your system configuration and version.
  
  
  
  Related Information:
  
  SAP IS-Oil Module: This module is specifically designed for the oil and gas industry and includes functionalities for managing well completions, allocations, and other related processes.
  Transaction Control Methods: Understanding the different transaction control methods available in SAP IS-Oil can help in configuring the system correctly.
  SAP Notes and Knowledge Base Articles: Check for any relevant SAP Notes or KBA (Knowledge Base Articles) that may address this specific error or provide additional troubleshooting steps.
  
  By following these steps, you should be able to identify the cause of the OIUPR380 error and implement the necessary solutions to resolve it.