How To Fix OIUPR024 - & & & & must exist on WC to Transporter Cross Reference table.

SAP Error Message - Details

• Message type: E = Error

• Message class: OIUPR - PRA Production Messages

• Message number: 024

• Message text: & & & & must exist on WC to Transporter Cross Reference table.

What causes this issue?

specifies product code 130 for oil and condensate mix, but the well
class is not oil or gas.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message OIUPR024 - & & & & must exist on WC to Transporter Cross Reference table. ?

  The SAP error message OIUPR024 indicates that a specific entry is missing in the Transporter Cross Reference table for a given Work Center (WC). This error typically arises in the context of logistics or production planning when the system is trying to process data related to transportation or production resources.
  Cause:
  The error occurs when:
  
  A Work Center (WC) is referenced in a transaction or process, but there is no corresponding entry in the Transporter Cross Reference table.
  The Transporter Cross Reference table is used to map work centers to transporters, and if the mapping is not set up correctly, the system cannot proceed with the operation.
  
  Solution:
  To resolve the OIUPR024 error, you can follow these steps:
  
  
  Check the Work Center Configuration:
  
  Go to the Work Center configuration in SAP (Transaction code: CR01 or CR02).
  Verify that the Work Center in question is correctly set up and active.
  
  
  
  Maintain the Transporter Cross Reference Table:
  
  Access the Transporter Cross Reference table (Transaction code: OIU1 or similar, depending on your SAP version).
  Check if the required entry for the Work Center exists. If it does not, you will need to create a new entry.
  Ensure that the Work Center is correctly linked to the appropriate transporter.
  
  
  
  Data Consistency:
  
  Ensure that all related data (such as transporters, work centers, and any other relevant master data) is consistent and correctly maintained in the system.
  
  
  
  Testing:
  
  After making the necessary changes, test the process again to ensure that the error is resolved.
  
  
  
  Consult Documentation:
  
  If you are unsure about the specific entries required, consult the SAP documentation or your organization's SAP support team for guidance on the Transporter Cross Reference table.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  CR01/CR02: Work Center Maintenance
  OIU1: Transporter Cross Reference Table Maintenance
  
  
  SAP Modules:
  
  This error is typically related to modules such as SAP Logistics (LO) or Production Planning (PP).
  
  
  Support:
  
  If the issue persists after following the above steps, consider reaching out to your SAP support team or consulting SAP Notes for any known issues or patches related to this error.
  
  
  
  By following these steps, you should be able to resolve the OIUPR024 error and ensure that your Work Center is properly configured in relation to the Transporter Cross Reference table.