How To Fix OIUME104 - Measurement type & not in work area.

SAP Error Message - Details

• Message type: E = Error

• Message class: OIUME - Measurement messages

• Message number: 104

• Message text: Measurement type & not in work area.

What causes this issue?

An internal error has occurred in the Measurement System. More
particularly, the current application has requested that measurement
type & be activated, but the Measurement System has not loaded
this value into the internal work area.

System Response

The current process is terminated.

How to fix this error?

This is an internal error and must be corrected by the application
development team.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message OIUME104 - Measurement type & not in work area. ?

  The SAP error message OIUME104, which states "Measurement type & not in work area," typically occurs in the context of the SAP system when dealing with measurement documents or measurement types in the context of the SAP Oil and Gas (O&G) module, particularly in the Measurement Management component.
  Cause:
  This error usually arises due to one of the following reasons:
  
  Measurement Type Not Defined: The measurement type you are trying to use is not defined in the relevant work area or configuration settings.
  Incorrect Configuration: The configuration for the measurement type may not be set up correctly in the system.
  Missing Authorization: The user may not have the necessary authorizations to access the measurement type in the specified work area.
  Data Inconsistency: There may be inconsistencies in the master data or configuration that prevent the system from recognizing the measurement type.
  
  Solution:
  To resolve the OIUME104 error, you can take the following steps:
  
  
  Check Measurement Type Configuration:
  
  Go to the configuration settings for measurement types in the SAP system (Transaction Code: OIU_MTYPE).
  Ensure that the measurement type in question is defined and correctly configured for the relevant work area.
  
  
  
  Verify Work Area Settings:
  
  Check the work area settings to ensure that the measurement type is included in the appropriate work area.
  You can do this by navigating to the relevant configuration settings in the SAP O&G module.
  
  
  
  Review User Authorizations:
  
  Ensure that the user encountering the error has the necessary authorizations to access the measurement type.
  You may need to consult with your SAP security team to verify and adjust user roles and permissions.
  
  
  
  Check Master Data:
  
  Review the master data related to the measurement type and ensure that it is consistent and correctly maintained.
  Look for any missing or incorrect entries that could lead to this error.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on measurement types and work areas in the context of your SAP version.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. They may provide insights specific to your system configuration.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as OIU_MTYPE for measurement type configuration and OIU_MES for measurement document processing.
  SAP Notes: Check for any SAP Notes related to this error message, as they may provide additional context or patches that address known issues.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify and resolve the cause of the OIUME104 error in your SAP system.