How To Fix OIJ_LDSCHED337 - Strapping time must be entered for end dip calculation

SAP Error Message - Details

• Message type: E = Error

• Message class: OIJ_LDSCHED - TSW: Load/Discharge Scheduling Message Class

• Message number: 337

• Message text: Strapping time must be entered for end dip calculation

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message OIJ_LDSCHED337 - Strapping time must be entered for end dip calculation ?

  The SAP error message OIJ_LDSCHED337, which states "Strapping time must be entered for end dip calculation," typically occurs in the context of the Oil and Gas industry within SAP, particularly when dealing with logistics and scheduling in the Oil Industry Solution (OIS).
  Cause:
  This error usually arises when the system requires a "strapping time" to be defined for the end dip calculation of a tank or storage facility, but this information has not been provided. Strapping time refers to the time taken to measure the liquid levels in a tank, which is essential for accurate inventory management and calculations.
  Solution:
  To resolve this error, you should take the following steps:
  
  
  Check Configuration:
  
  Ensure that the strapping time is configured correctly in the system. This can typically be done in the tank or storage location master data.
  Navigate to the relevant configuration settings in SAP and verify that the strapping time is defined.
  
  
  
  Enter Strapping Time:
  
  If the strapping time is not set, you will need to enter it. This can usually be done in the tank master data or during the scheduling process.
  Go to the relevant transaction (e.g., OIJ_TANK) and enter the required strapping time.
  
  
  
  Review Master Data:
  
  Check the master data for the tank or storage facility involved in the transaction. Ensure that all necessary fields, including strapping time, are filled out correctly.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources specific to the Oil Industry Solution for detailed guidance on how to manage strapping times and related settings.
  
  
  
  Testing:
  
  After entering the strapping time, perform a test transaction to ensure that the error does not reoccur.
  
  
  
  Contact Support:
  
  If the issue persists after following the above steps, consider reaching out to your SAP support team or consulting with an SAP expert who specializes in the Oil and Gas module.
  
  
  
  Related Information:
  
  Strapping Procedures: Understanding the strapping procedures and how they relate to inventory management in the Oil and Gas industry can be beneficial.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional context.
  Training: Consider training sessions or workshops on SAP OIS to better understand the logistics and scheduling functionalities.
  
  By following these steps, you should be able to resolve the OIJ_LDSCHED337 error and ensure that your end dip calculations are accurate.