How To Fix OC827 - Tank dip below min.fltg roof height of &, no fltg.roof correction applied

SAP Error Message - Details

• Message type: E = Error

• Message class: OC - IS-Oil: BDRP Bulk Distribution Requirement Planning messages

• Message number: 827

• Message text: Tank dip below min.fltg roof height of &, no fltg.roof correction applied

What causes this issue?

The dip height is below the minimum floating roof height. Therefore, no
floating roof correction was applied.

System Response

The product volume will be calculated without the floating roof
correction.

How to fix this error?

A business add-in can be used to handle the floating roof correction in
the height below the minimu floating roof height.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message OC827 - Tank dip below min.fltg roof height of &, no fltg.roof correction applied ?

  The SAP error message "OC827 Tank dip below min. fltg roof height of &, no fltg. roof correction applied" typically occurs in the context of tank management within SAP, particularly when dealing with tank measurements and calculations related to floating roofs.
  Cause:
  This error indicates that the measured dip (the distance from the top of the tank to the liquid surface) has fallen below the minimum floating roof height. This situation can arise due to several reasons:
  
  Incorrect Measurement: The dip measurement may have been taken incorrectly, leading to an inaccurate reading.
  Tank Overdraw: The liquid level in the tank may have dropped below the minimum height due to excessive withdrawal or consumption of the liquid.
  Floating Roof Issues: There may be a problem with the floating roof itself, such as it being stuck or not functioning properly.
  Configuration Issues: The tank may not be configured correctly in the SAP system, leading to incorrect minimum height settings.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  Verify Measurements: Check the dip measurement to ensure it was taken correctly. If necessary, re-measure the dip.
  Check Liquid Levels: Inspect the tank to see if the liquid level is indeed below the minimum floating roof height. If it is, consider replenishing the tank.
  Inspect Floating Roof: Examine the floating roof for any mechanical issues that may prevent it from functioning correctly.
  Review Tank Configuration: Ensure that the tank is configured correctly in the SAP system, including the minimum floating roof height settings. Adjust these settings if necessary.
  Consult Documentation: Refer to SAP documentation or consult with your SAP support team for specific guidance related to your system configuration and setup.
  
  Related Information:
  
  SAP Modules: This error is typically encountered in modules related to Materials Management (MM) or Plant Maintenance (PM) where tank management is involved.
  Tank Management: Understanding how tank management works in SAP, including the concepts of dip measurement, floating roofs, and tank configurations, can help in troubleshooting similar issues.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  If the issue persists after following these steps, it may be beneficial to engage with SAP support or a consultant who specializes in SAP tank management for further assistance.