How To Fix MS610 - Test data has already been stored in file &1

MS610 - Overview

• Message type: E = Error

• Message class: MS - SAP customer enhancement project messages

• Message number: 610

• Message text: Test data has already been stored in file &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message MS610 - Test data has already been stored in file &1 ?

  The SAP error message MS610 indicates that test data has already been stored in the specified file. This typically occurs in the context of testing or simulation scenarios where data is being written to a file, and the system detects that the file already contains data from a previous test run.
  
  Cause:
  The primary cause of this error is that the system is attempting to write test data to a file that has already been used to store test data. This can happen if:
  
  A previous test run was not cleared or reset.
  The file was not properly deleted or overwritten before the new test run.
  The configuration or settings for the test data generation are not set to allow overwriting.
  
  
  Solution:
  To resolve the MS610 error, you can take the following steps:
  
  
  Check the File: Verify the contents of the file specified in the error message. If it contains old test data, you may need to delete