How To Fix MPN02006 - Part &1 is held in &3 MPN-MRP set in plant &2

MPN02006 - Overview

• Message type: E = Error

• Message class: MPN02 - MPN Message: Materials Planning

• Message number: 006

• Message text: Part &1 is held in &3 MPN-MRP set in plant &2

What causes this issue?

<DS:GLOS.3608C3DABA271348E10000009B38F91F>MPN-MRP sets</> cannot
overlap in the same plant. Material &V1& has however been assigned to
&V3& MPN-MRPset in plant &V2&.

How to fix this error?

Please assign a material only to one MPN-MRP set at the most per plant.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message MPN02006 - Part &1 is held in &3 MPN-MRP set in plant &2 ?

  The SAP error message MPN02006 indicates that a specific part (material) is being held in a Multi-Plant Network (MPN) Material Requirements Planning (MRP) set in a particular plant. This typically means that the material is not available for planning or procurement due to certain restrictions or settings in the MPN configuration.
  
  Cause:
  
  Material Status: The material may have a status that prevents it from being used in MRP, such as being marked as "blocked" or "inactive."
  MPN Configuration: The MPN settings for the material in the specified plant may not be correctly configured, leading to restrictions on its availability.
  Plant-Specific Settings: There may be specific settings at the plant level that restrict the material from being included in MRP calculations.
  MRP Type: The MRP type assigned to the material may not be suitable for the planning process, such as being set to "not planned."
  
  
  Solution:
  
  Check Material Status: Review the status of the material in the system.