How To Fix MMRP01511 - Time bucket &1 replaced by &2 in component variant &3

SAP Error Message - Details

• Message type: E = Error

• Message class: MMRP01 - Rapid Planning Matrix

• Message number: 511

• Message text: Time bucket &1 replaced by &2 in component variant &3

What causes this issue?

You wanted to use the period profile &V1& in the component variant &V3&
.

System Response

The system, however, has determined that this is not possible and
attempts to replace the period profile &V1& with &V2&.
Causes can be:
The period profile does not exist
The time stream for resource &V4& is not long enough
The capacity data at the resource has been maintained adequately

How to fix this error?

<DS:TRAN./SAPAPO/RES01>Check the data for the resource</> &V4&.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message MMRP01511 - Time bucket &1 replaced by &2 in component variant &3 ?

  The SAP error message MMRP01511 indicates that there is a conflict in the time bucket settings for a component variant in a production planning or material requirements planning context. Specifically, it means that the time bucket specified (e.g., a specific period for planning) has been replaced by another time bucket due to some configuration or data inconsistency.
  Cause:
  
  Configuration Issues: The time bucket settings in the material master or the planning strategy may not be aligned with the requirements of the component variant.
  Data Inconsistencies: There may be inconsistencies in the data related to the time buckets defined for the component variant, such as overlapping periods or incorrect definitions.
  Planning Parameters: The planning parameters set for the material or component variant may not support the specified time bucket, leading to a fallback to a default or alternative time bucket.
  
  Solution:
  
  Review Time Bucket Settings: Check the time bucket settings in the material master and ensure they are correctly defined. Make sure that the time buckets do not overlap and are set according to the planning requirements.
  Adjust Planning Parameters: Review the planning parameters for the component variant and ensure they are set correctly to accommodate the desired time bucket.
  Check Component Variant Configuration: Verify the configuration of the component variant to ensure that it is set up correctly and that all relevant settings are aligned.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on time bucket settings and their implications in your planning scenario.
  Testing: After making adjustments, perform tests to ensure that the error does not recur and that the planning runs as expected.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like MM02 (Change Material), MD04 (Stock/Requirements List), or MD01 (MRP Run) to review and adjust settings.
  SAP Notes: Check for any relevant SAP Notes that may address known issues or provide additional guidance on this error message.
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  If the issue persists after following these steps, it may be beneficial to consult with your SAP support team or a technical consultant who can provide deeper insights into the specific configuration of your SAP environment.