How To Fix MMRP01180 - Material &2 not found in location &3 (planning version &1)

SAP Error Message - Details

• Message type: E = Error

• Message class: MMRP01 - Rapid Planning Matrix

• Message number: 180

• Message text: Material &2 not found in location &3 (planning version &1)

What causes this issue?

The system could not find a pegging area for material &V2& in location
&V3& and planning version &V1&.

System Response

The required component was not fixed.

How to fix this error?

Check your entries and the corresponding master data.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message MMRP01180 - Material &2 not found in location &3 (planning version &1) ?

  The SAP error message MMRP01180 indicates that a specific material (denoted as &2) cannot be found in a specified location (denoted as &3) for a given planning version (denoted as &1). This error typically arises in the context of materials management and planning processes within SAP.
  Cause:
  
  Material Not Created: The material may not have been created in the system for the specified location.
  Incorrect Location: The location specified may not be valid for the material in question.
  Planning Version Issues: The planning version may not be set up correctly, or the material may not be included in that version.
  Data Inconsistency: There may be inconsistencies in the master data or configuration settings that prevent the system from recognizing the material in the specified location.
  Authorization Issues: The user may not have the necessary authorizations to view or access the material in that location.
  
  Solution:
  
  Check Material Master: Verify that the material exists in the system. You can do this by using transaction code MM03 to display the material master data.
  Verify Location: Ensure that the location specified in the error message is correct and that the material is indeed supposed to be available at that location.
  Check Planning Version: Confirm that the planning version is correctly set up and that the material is included in that version. You can check this in the planning settings or by using transaction code MD61 (for planning).
  Data Consistency Check: Run consistency checks on the material master data to identify any discrepancies. This can be done using transaction codes like MM02 (to change material) or MM01 (to create material) to review the data.
  Authorization Check: Ensure that the user has the necessary authorizations to access the material and location. This can be checked with the security team or by reviewing user roles and permissions.
  Consult Documentation: If the issue persists, consult SAP documentation or reach out to SAP support for further assistance.
  
  Related Information:
  
  Transaction Codes: MM03 (Display Material), MM02 (Change Material), MD61 (Create Planning), and MD04 (Stock/Requirements List).
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed and resolved.
  
  By following these steps, you should be able to identify the root cause of the MMRP01180 error and implement the appropriate solution.