How To Fix MILL083 - Unit of measure & not convertible to stockkeeping unit &

SAP Error Message - Details

• Message type: E = Error

• Message class: MILL - Messages in IS Mill Products

• Message number: 083

• Message text: Unit of measure & not convertible to stockkeeping unit &

What causes this issue?

An error occurred during conversion between the
<GL:stockkeeping unit>stockkeeping unit</> and an alternative unit.

System Response

The system changes the alternative unit entered to the stockkeeping
unit.

How to fix this error?

INCLUDE NA_SYSADMIN1

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message MILL083 - Unit of measure & not convertible to stockkeeping unit & ?

  The SAP error message MILL083 indicates that there is an issue with the conversion of a unit of measure (UoM) to a stockkeeping unit (SKU) in the context of inventory management or material management. This error typically arises when the system is unable to convert the specified unit of measure into the stockkeeping unit due to a lack of defined conversion factors or incompatible units.
  Cause:
  
  Missing Conversion Factors: The most common cause is that the conversion factors between the unit of measure and the stockkeeping unit are not defined in the system.
  Incorrect Unit of Measure: The unit of measure being used may not be valid for the material or may not be set up correctly in the system.
  Configuration Issues: There may be configuration issues in the material master or in the unit of measure settings.
  Data Inconsistencies: There could be inconsistencies in the data related to the material master or the unit of measure settings.
  
  Solution:
  
  
  Check Material Master: 
  
  Go to the material master record (transaction code MM03) and check the unit of measure settings. Ensure that the stockkeeping unit is correctly defined and that the conversion factors are set up properly.
  
  
  
  Define Conversion Factors:
  
  If conversion factors are missing, you can define them in the material master under the "Units of Measure" view. Make sure to specify the correct conversion from the unit of measure to the stockkeeping unit.
  
  
  
  Review Unit of Measure Settings:
  
  Check the configuration of units of measure in the system (transaction code OMT3E). Ensure that the units are correctly defined and that they are compatible with the stockkeeping unit.
  
  
  
  Check for Data Inconsistencies:
  
  Run consistency checks on the material master data to identify any discrepancies that may be causing the issue.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on handling unit of measure issues.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: 
  
  MM03 (Display Material), MM02 (Change Material), OMT3E (Maintain Units of Measure).
  
  
  SAP Notes: Check for any relevant SAP Notes that may address known issues related to unit of measure conversions.
  User Forums: Engage with SAP community forums or user groups for additional insights and solutions from other users who may have encountered similar issues.
  
  By following these steps, you should be able to resolve the MILL083 error and ensure that the unit of measure is correctly convertible to the stockkeeping unit.