How To Fix MG555 - Enter a degree between 0 and 89 for the maximum slope for bridges

SAP Error Message - Details

• Message type: E = Error

• Message class: MG - Batch input: material master

• Message number: 555

• Message text: Enter a degree between 0 and 89 for the maximum slope for bridges

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message MG555 - Enter a degree between 0 and 89 for the maximum slope for bridges ?

  The SAP error message MG555, which states "Enter a degree between 0 and 89 for the maximum slope for bridges," typically occurs in the context of configuring bridge parameters in SAP's logistics or transportation modules. This error indicates that the value entered for the maximum slope of a bridge is outside the acceptable range.
  Cause:
  The error is triggered when the user inputs a value for the maximum slope that is either less than 0 or greater than 89 degrees. In the context of bridge design and logistics, slopes are usually defined within this range to ensure safety and feasibility.
  Solution:
  To resolve this error, follow these steps:
  
  
  Check Input Value: Review the value you have entered for the maximum slope of the bridge. Ensure that it is a numerical value between 0 and 89 degrees.
  
  
  Correct the Value: If the value is outside the specified range, correct it to a valid number within the range. For example, if you entered 95 degrees, change it to a value like 45 degrees.
  
  
  Save Changes: After making the necessary adjustments, save the changes and try to proceed with the transaction or configuration again.
  
  
  Validation: If you are unsure about the appropriate slope value, consult relevant engineering guidelines or standards for bridge design, or check with a qualified engineer.
  
  
  Related Information:
  
  SAP Documentation: Refer to the SAP Help Portal or specific module documentation for more details on bridge configuration and parameters.
  User Training: If you frequently encounter this error, consider training sessions or resources on the specific SAP module you are using, focusing on logistics and transportation management.
  Support: If the issue persists after correcting the input, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  By ensuring that the maximum slope value is correctly set within the specified range, you should be able to resolve the MG555 error and continue with your work in SAP.