How To Fix MDM_XFW_CONFIG001 - Enter a target system

SAP Error Message - Details

• Message type: E = Error

• Message class: MDM_XFW_CONFIG - Configuration of Extraction on the Client

• Message number: 001

• Message text: Enter a target system

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message MDM_XFW_CONFIG001 - Enter a target system ?

  The SAP error message MDM_XFW_CONFIG001 typically indicates that a target system has not been specified in the configuration settings for the Master Data Management (MDM) system. This error can occur in various contexts, such as during data transfer or when trying to configure the MDM system to communicate with other systems.
  Cause:
  The primary cause of this error is that the target system, which is necessary for the data transfer or synchronization process, has not been defined in the MDM configuration settings. This could happen due to:
  
  Incomplete Configuration: The MDM system has not been fully configured, and the target system details were not provided.
  User Error: The user may have overlooked entering the target system information.
  System Changes: Changes in the system landscape or updates may have led to the loss of target system configuration.
  
  Solution:
  To resolve the MDM_XFW_CONFIG001 error, follow these steps:
  
  Access MDM Console: Log in to the MDM Console or the relevant configuration interface.
  Navigate to Configuration Settings: Go to the section where you can configure the target systems.
  Specify Target System: Enter the required details for the target system, including:
  
  System name
  Connection parameters (like host, port, etc.)
  Any necessary authentication details
  
  
  Save Configuration: After entering the target system information, save the configuration settings.
  Test Connection: If possible, test the connection to ensure that the MDM system can communicate with the target system successfully.
  Restart Services: If necessary, restart any relevant services or processes to apply the changes.
  
  Related Information:
  
  Documentation: Refer to the official SAP MDM documentation for detailed instructions on configuring target systems.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Support: If the issue persists after following the above steps, consider reaching out to SAP support for further assistance.
  
  By ensuring that the target system is correctly configured, you should be able to resolve the error and continue with your MDM processes.