How To Fix MDGBP000 - Archiving object &1 is not assigned to any application object

SAP Error Message - Details

• Message type: E = Error

• Message class: MDGBP - Master Data Governance: Business Partner specific messages

• Message number: 000

• Message text: Archiving object &1 is not assigned to any application object

What causes this issue?

The currently specified archiving object is not assigned to an
application object of the Business Data Toolset (BDT).

System Response

Termination of the archiving run.

How to fix this error?

Run Transaction BUS0. Specify the relevant archiving object in the data
for you application object.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message MDGBP000 - Archiving object &1 is not assigned to any application object ?

  The SAP error message MDGBP000 indicates that the archiving object specified (denoted as &1 in the message) is not assigned to any application object. This typically occurs when there is an attempt to archive data for an object that has not been properly configured or linked to an application.
  Cause:
  
  Missing Configuration: The archiving object may not be configured correctly in the system. This can happen if the archiving object was created but not assigned to any application object.
  Incorrect Object Reference: The archiving object being referenced may not exist or may have been deleted or deactivated.
  Transport Issues: If the archiving object was transported from another system, it may not have been properly set up in the target system.
  
  Solution:
  
  
  Check Archiving Object Configuration:
  
  Go to transaction SARA (Archive Administration).
  Check the configuration of the archiving object in question. Ensure that it is properly assigned to the relevant application object.
  If necessary, reassign the archiving object to the appropriate application.
  
  
  
  Review Application Object Assignment:
  
  Verify that the application object you are trying to archive is correctly set up and linked to the archiving object.
  You can check the assignment in the customizing settings (transaction SPRO) under the relevant application area.
  
  
  
  Transport and System Consistency:
  
  If the archiving object was transported, ensure that all necessary customizing settings and dependencies were also transported.
  Check for any inconsistencies in the system that may have resulted from the transport.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the specific archiving object for any additional configuration steps or prerequisites.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance. They may provide specific notes or patches related to the archiving object.
  
  
  
  Related Information:
  
  Transaction Codes:
  
  SARA: Archive Administration
  SPRO: Customizing (Implementation Guide)
  
  
  SAP Notes: Search for relevant SAP Notes in the SAP Support Portal that may address known issues with the specific archiving object.
  Documentation: Review the SAP Help Portal for detailed information on archiving processes and best practices.
  
  By following these steps, you should be able to resolve the MDGBP000 error and successfully configure the archiving object for use in your SAP system.